Question

the picture which is in the question, it is show in the yellow device below.

please answer all the parts of the question

5 Observe the below figure and answer all questions: Nearest Switch TAC_C-pod IP: 010 248.001.004 Port: 29 VLAN: Interface: 1Gb Hosts: 12 Port utilization (BW) Pkts in: 100% 731 10% Pkts out: 1% 741 Errors (% packets) 100% Ens In: 10% Ens Out: 1% 0 Test Status Connection Link 10Mb half duplex & Cable Verification 12 f to active device Signal Verlication Link 10Mb half duplex Local Statistics BW: <1%, peak: 4.6%, avg: 0.2% on Protocol Statistics Running.. Top Talkers Running... 3 Device Discovery 42 devices 12.Network Discovery 2 IP, 3 NetBIOS 1.VLAN Discovery 2 VLANS Nearest Switch TAC_C-pod(port 29) Switch Scan Monitoring 2 switches Key Devices All devices responding Probiern Detection 3 detected SERIKSS 0 10Mb Details Restart all a ? 1. What does the above figure show you? 2. Which device can show you this type of information? 3. Explain the use, advantages and features of this device? 4. How you connect this device? 5. Explain the meaning of the status “link 10Mb half duplex” in connection? 6. From which menu you can find the number of PCs connected to the network? [0.5 marks) [0.5 marks) [1 mark] [1 mark] [1 mark] [1 mark]

Answer 1

Solution

1.The above figure shows a ethernet traffic controller taken by etherscope.It shows all the communications ,datatransfer to and fro in a network.

2.This type of information is taken by etherscope (a handheld tool to offer a single user interface that fully integrates both wired and wireless network test data, the EtherScope increases network visibility, accelerates and simplifies testing)

3.Use of the device:It offers single UI that integrates both wired and wireless network test data;Solves ethernet problems,discovers switches faster;Monitor client access,Identifies network status

Advantage:Its availability as portable tool makes troubleshooting in network faster

Features: wifi connectivity,ethernet support

4.The device is connected using wifi.

5.Ethernet links occurs when one port on the link operates at half-duplex.

6.The number of PC's connected to the network can be seen under the menu Device Discovery