In the figure, R 2 ohms. Replace the 9 ohm resistor at the bottom by a...
Resistor 1 of 7 Ohms, resistor 2 of 6 Ohms, and resistor 3 of 13 Ohms are connected purely in series to a battery. The current through resistor 1 is 4.9 amps. What is the power dissipated by resistor 2 in Watts?
What current is flowing through the bottom wire? If the current is to the left, answer as negative current, if the current is to the right, answer as positive. Round to 2 significant figures in units of amps (+/-5% error). Hint: It's not zero. What current is flowing through the bottom wire? If the current is to the left, answer as negative current, if the current is to the right, answer as positive. Round to 2 significant figures in units...
Find the Thévenin equivalent with respect to the terminals a,b for the circuit in (Figure 1) if v = 360 V, i = 4 A. Figure 1 of 1The figure shows a rectangular circuit. A vertical cross wire connects the top and bottom wires. An 8-ohm resistor is located on this cross wire. A 40-ohm and a 10-ohm resistors are located on the top wire to the left and right from the cross wire, respectively. Independent voltage source v, with...
QUESTION 2 A battery, a 40 ohm resistor, and a 60 ohm resistor are all in parallel If there are 5 A of current flowing through the battery, how much current is flowing through the 60 ohm resistor? O2A 3A 5A OTA QUESTION 3 Click Save and Submit to save and submit. Click Save All Answers to save all answers, Save All Answers
PLEASE DO NOT ANSWER UNLESS YOU ARE %100 SURE Fig. ACNodal2 In the circuit, Ri=6 Ohm, R2 = 9 Ohm, R3 = 4 Ohm, the reactances of inductors and capacitor are XL1=7 Ohm, XL2=3.5 Ohm, XCI=4.2 Ohm; voltage source amplitude and phase are 11 V and 0.12 rad. Using nodal analysis, find the following 1) The amplitude of the potential at the top lead of inductor L1. (Unit: V) 7.350 V Computer's answer now shown above. You are correct. Previous...
PLEASE HELP IMMEDIATELY R2 R3 R1 C1 C2 S2 51 In the circuit, the signal frequency f = 1.2 MHz, R1=9 Ohm, R2 = 8 Ohm, R3 = 7 Ohm, C1-22 nF, C2=25 nF; The voltage source Vs1 amplitude and phase are 15 V and 0.12 rad; the voltage source Vs2 amplitude and phase are 4 V and 0.4 rad. (Note the polarity of the voltage sources!) Using nodal analysis, find the following 1) The amplitude of the potential at...
power supply (E): 15V Resistor 1 has a resistance of 2.5 ohms Resistor 2 has a resistance of 4 ohms What is the current flowing through the Resistor 2? Bin ma
Problem 06 СХС VS1 = VS1m 20s1 VS2 = VS2M 202 In the circuit, R=6 Ohm, XL=3 Ohm, XC=9 Ohm; VS1 amplitude and phase are 12 V and O rad, VS2 amplitude and phase are 45 V and 0.9 rad. Using MESH Analysis, find the following 1a) The amplitude of the current through the resistor R flowing from left to right. (Unit: A) Submit Answer Tries 0/3 1b) The phase of the current through the resistor R flowing from left...
answer using Matlab or Octave please Fig.ACNodal2 In the circuit, R1-8 Ohm, R2 = 10 Ohm, R3 - 4 Ohm, the reactances of inductors and capacitor are XL1=4 Ohm, XL21 Ohm, XC1=2 Ohm; voltage source amplitude and phase are 11 V and O rad. Using nodal analysis, find the following 1) The amplitude of the potential at the top lead of inductor L1. (Unit: V) Submit Answer Tries 0/3 2) The phase of of the potential at the top lead...
Ri Vs S1 Q2. In the circuit, Vs 1 = 80 V, R1 = 4 Ohm, R2 = 28 Ohm, R3 = 94 Ohm, R4 = 8 Ohm and R5 = 27 Ohm. 1) Find the current through R1 flowing left to right. (Unit: A) Submit Answer Tries 0/5 2)Find the current through R2 flowing downwards. (Unit: A) Submit Answer Tries 0/3 3) Find the current through R3 flowing left to right. (Unit: A) Submit Answer Tries 0/3 4) Find...