Homework Answers
when R=8k then diode in
reverse bias because when input resiatance is high then there is
max votlage drop so diode is reverse bias and it is open circuit
then then is there is no flow of current .
Current through diode is 0A
Add Answer to:
Figure 1 2. Assuming Vy 0.7V, find the current flowing through the diode for the circuit...
Problem 1. In the circuit below, assume the 0.7V drop model for the diode, and use...
Problem 1. In the circuit below, assume the 0.7V drop model for the diode, and use nV 25 mV The value of the capacitor is chosen suchthat the 385 Ω resistor R is short-circuited at the small signal operating frequency w. a) Determine the value of the diode current Ip under DC conditions. b) Determine the small resistance rp, and draw the resulting small signal circuit c) Determine the small signal current flowing through the circuit. R | 15 Ω...
The current flowing to the diode in the following circuit is 5 mA and the current flowing to the ...
The current flowing to the diode in the following
circuit is 5 mA and the current flowing to the load is 20 mA. I(0)
is always 25 mA and if the current flowing into the Load changes to
21 mA, what is the voltage (ΔV(out)) applied to both ends of the
Load?
-Use 'Small sinal model'
-R(1)>>3r(d)
Diode Bridge in Load Vout
Diode Bridge in Load Vout
Calculate the current flowing in the circuit below. The temperature is 300K. The battery voltage is...
Calculate the current flowing in the circuit below. The temperature is 300K. The battery voltage is 5 V. The resistance R-1000 Ohms. The equation for current through the diode isi 10 9 [op{VANT) - 11 Amperes. Vd is the voltage drop across the diode and Vt is thermal voltage 1) Calculate the current flowing in the circuit below. The temperature is 300K. The battery voltage 15V. The resistance R-2000 Ohms. The equation for current through the diode is 19 (exp/Vd/T)...
For the double diode circuit shown in figure 2-1, answer the following questions. In Figure 2-1...
For the double diode circuit shown in figure 2-1, answer the following questions. In Figure 2-1 a) (10pts) For the triangular wave input shown (Vin), sketch the output voltage (Vout) using the constant voltage drop model (CVD: Vo-0.7V). Be sure to note the voltage values on the y-axis of your Vout plot and show any equations you used to determine those values ime FEE 334: Spring 2019 Midterm b) (2pts) During the middle of the first time segment (when Vin...
Find the current flowing through the circuit of the figure, assuming you have a 12.60V source,...
Find the current flowing through the circuit of the figure,
assuming you have a 12.60V source, and the resistance values are R1
= 1.60kΩ, R2 = 12.00kΩ, R3 = 4.40kΩ and R4 = 108.00kΩ. Express your
answer in mA.
.V R1 R2 R3 R4 2 w Liw
(25 pts)For the circuit below assuming an ideal diode with a 0.7 V drop (You must...
(25 pts)For the circuit below assuming an ideal diode with a 0.7 V drop (You must fill in the information in the boxes below): a. Sketch Vout VS. Vin- b. When Vin -5V: Determine which diode leg is conducting, the current flowing through the diode, and Vout? c. Find the values in part b when Vin 0.3V? d. Find the values in part b when Vin 3V? R 1-2k, R2 = 6k. R1 R2 D2 Vout DI R2
lai). In the diode circuit below use iterative method (use at least 3 iterations) to find...
lai). In the diode circuit below use iterative method (use at least 3 iterations) to find the diode voltage and current, if VDD=2.0 V, R= 1 KO2, the diode has Is - 10e- 15 A Find diode voltage and current using constant 0.7 V drop model. comment on the results of (i) and (ii) (iii) ang DV. b. Both diodes in the circuit below are rated 0.7V, 1mA. R=1KN Sketch vo vs vi If vi = 2sinot, on the same...
1. The reverse current in a diode has a value of 71.8 nA when the reverse...
1. The reverse current in a diode has a value of 71.8 nA when the reverse voltage across the diode is 324.99 V. If the breakdown voltage of the diode is 325 V, and its saturation current is 11.0 pA, calculate the value of n for this diode. Ans. (2-12 Bogart) n 4.979 2. For the circuit below with silicon diodes, which diodes are forward-biased and which are revers- biased? Is current flowing through the resistor? If so, draw a...
Problem 1. Find the current I and V, in the circuit. Turn on voltage of the...
Problem 1. Find the current I and V, in the circuit. Turn on voltage of the diode is 0.7V. (10 points) 1+5V Problem 2. Find the current and V, in the circuit. Turn on voltage of the diode is 0.7V. (10 points) + +5V BR-4.30 PV
Calculate the (a) current flowing in the circuit below and (b) voltage drop across the resistor...
Calculate the (a) current flowing in the circuit below and (b) voltage drop across the resistor Ron the right. The temperature is 600K. The battery voltage is 5 V. The resistance R-1 Giga Ohm. The equation for current through the diode is 1" 18 9 (exp/Vd/(2*VT)) - 1) Amperes. Vd is the voltage drop across the diode and VT is thermal voltage. Do not forget that this is diode with 2 as shown in the equation above. (1 Giga -...
Problem 1. In the circuit below, assume the 0.7V drop model for the diode, and use nV 25 mV The value of the capacitor is chosen suchthat the 385 Ω resistor R is short-circuited at the small signal operating frequency w. a) Determine the value of the diode current Ip under DC conditions. b) Determine the small resistance rp, and draw the resulting small signal circuit c) Determine the small signal current flowing through the circuit. R | 15 Ω...
The current flowing to the diode in the following
circuit is 5 mA and the current flowing to the load is 20 mA. I(0)
is always 25 mA and if the current flowing into the Load changes to
21 mA, what is the voltage (ΔV(out)) applied to both ends of the
Load?
-Use 'Small sinal model'
-R(1)>>3r(d)
Diode Bridge in Load Vout
Diode Bridge in Load Vout
Calculate the current flowing in the circuit below. The temperature is 300K. The battery voltage is 5 V. The resistance R-1000 Ohms. The equation for current through the diode isi 10 9 [op{VANT) - 11 Amperes. Vd is the voltage drop across the diode and Vt is thermal voltage 1) Calculate the current flowing in the circuit below. The temperature is 300K. The battery voltage 15V. The resistance R-2000 Ohms. The equation for current through the diode is 19 (exp/Vd/T)...
For the double diode circuit shown in figure 2-1, answer the following questions. In Figure 2-1 a) (10pts) For the triangular wave input shown (Vin), sketch the output voltage (Vout) using the constant voltage drop model (CVD: Vo-0.7V). Be sure to note the voltage values on the y-axis of your Vout plot and show any equations you used to determine those values ime FEE 334: Spring 2019 Midterm b) (2pts) During the middle of the first time segment (when Vin...
Find the current flowing through the circuit of the figure,
assuming you have a 12.60V source, and the resistance values are R1
= 1.60kΩ, R2 = 12.00kΩ, R3 = 4.40kΩ and R4 = 108.00kΩ. Express your
answer in mA.
.V R1 R2 R3 R4 2 w Liw
(25 pts)For the circuit below assuming an ideal diode with a 0.7 V drop (You must fill in the information in the boxes below): a. Sketch Vout VS. Vin- b. When Vin -5V: Determine which diode leg is conducting, the current flowing through the diode, and Vout? c. Find the values in part b when Vin 0.3V? d. Find the values in part b when Vin 3V? R 1-2k, R2 = 6k. R1 R2 D2 Vout DI R2
lai). In the diode circuit below use iterative method (use at least 3 iterations) to find the diode voltage and current, if VDD=2.0 V, R= 1 KO2, the diode has Is - 10e- 15 A Find diode voltage and current using constant 0.7 V drop model. comment on the results of (i) and (ii) (iii) ang DV. b. Both diodes in the circuit below are rated 0.7V, 1mA. R=1KN Sketch vo vs vi If vi = 2sinot, on the same...
1. The reverse current in a diode has a value of 71.8 nA when the reverse voltage across the diode is 324.99 V. If the breakdown voltage of the diode is 325 V, and its saturation current is 11.0 pA, calculate the value of n for this diode. Ans. (2-12 Bogart) n 4.979 2. For the circuit below with silicon diodes, which diodes are forward-biased and which are revers- biased? Is current flowing through the resistor? If so, draw a...
Problem 1. Find the current I and V, in the circuit. Turn on voltage of the diode is 0.7V. (10 points) 1+5V Problem 2. Find the current and V, in the circuit. Turn on voltage of the diode is 0.7V. (10 points) + +5V BR-4.30 PV
Calculate the (a) current flowing in the circuit below and (b) voltage drop across the resistor Ron the right. The temperature is 600K. The battery voltage is 5 V. The resistance R-1 Giga Ohm. The equation for current through the diode is 1" 18 9 (exp/Vd/(2*VT)) - 1) Amperes. Vd is the voltage drop across the diode and VT is thermal voltage. Do not forget that this is diode with 2 as shown in the equation above. (1 Giga -...
Most questions answered within 3 hours.
-
A newly developed artificial intelligence has trouble
distinguishing hand-written numbers from hand-written alphabets.
There are pictures...
asked 11 minutes ago -
The carbonate ion CO3 2- has multiple resonance structures.
a. Draw them and assign the hybridization...
asked 4 minutes ago -
In doing an allocation for a basket purchase
Use the individual costs and the total market...
asked 12 minutes ago -
what were the social political and economic causes and impacts of
the late 19th century urban...
asked 10 minutes ago -
if the magnitude of a velocity vector is 10m/s and it
makes an angle of 45...
asked 12 minutes ago -
Which amino acid has a basic R group?
A) tyrosine
B) Isoleucine
C) Glutamic Acid
D)...
asked 24 minutes ago -
Is there the need for the government to have hackers. Please
share your thoughts.
asked 27 minutes ago -
Explain why you should not lose any LDH activity when you
centrifuge a crude sample at...
asked 36 minutes ago -
An AA battery (object), standing on end, is placed to the left
of a diverging lens...
asked 37 minutes ago -
After you measure the self-inductance of a coil, you unwind it
and then rewind one third...
asked 37 minutes ago -
1. Which of the following best describes a transistor?
A) a small electrical circuit made from...
asked 38 minutes ago -
Use generating function to find the number of distributions of
20 people into four different rooms...
asked 54 minutes ago