I would observe the disappearance of a signal at around 1750 cm-1 and appearance of a signal at about 3500 cm-1.
I am perfroming the reduction if camphor and I decide to analyze my product by IR....
If you could help
explain the chart above, that would be awesome.
4. Analyze the IR spectrum of your product, filling in the table below. You should utilize your course textbook (pp. 764-766), if you need assistance. Please note that the frequency given below should be exact (one number), not a range. Use the frequency of the center of the band at its strongest point. Then, on the spectrum itself, mark the characteristic bands at their strongest point with a...
please help me analyze my IR
my starting materials were
1.1 g of 1-pentanol
2.29g butyric acid
final product- 0.44g
experiment: fischer esterification
our product pentyl butyrate
Analyst Date Administrator Friday, November 01, 2019 4:03 PM Friday, November 01, 2019 403 PM PertanElmer Spectrum Version 1042 Am 216.10cm-1 %T P8404cm-1 1463.97cm-1 01.93cm-1 1253 934-1 29600m-1 3500 3000 1735 pacm-1 2500 2000 cm-1 1500 1179. 15cm-1 1000 Administrator 124 650 Sample 124 By Administrator Date Friday, November 01 2019
I
determined this as the product of my aldol reaction I performed
with 4-methoxybenzaldehyde and 3'-methoxyacetophenone. It was
approved by my supervisor so I am pretty confident it is correct.
Looking at the IR spectra, there is a large broad peak at
~3300, which I know usually indicates alcohol or acids. There is no
alkyne or amine in the structure. What could account for this peak?
Is it just a spectrometry fluke or am I just missing something...
(I used...
This is one of my lab reports, I am curious if I have done it right? Can anyone help? Data And Lab Report Submission - Hydration Of 1-Hexene Hydration of 1-Hexene Data Collection Amount of reactant used in grams 0.694 Product obtained in grams 0.785 (24pts) Calculations Use the mass of reactant and product recorded above to complete the following calculations. (4pts) Amount of reactant in moles (4pts) Product obtained in moles (6pts) Product theoretical yield (g) (6pts) Product percent...
I am trying to identify an unknown but have had some
trouble.
The IR shows strong sharp peaks at approximately 2965 cm^-1 and
1746 cm^-1.
The m/z seems to be 86.
Proton NMR shows a quartet at 2.5 ppm, and a triplet at 1.0
ppm.
C13 NMR shows peaks at 11, 46, and 76 ppm.
Is my m/z correct based on the MS?
I suspect the unknown might be cyclopentanone or pentan-3-one.
Any hits would be useful. Thank you.
4000...
For this question, I am wondering about why my math isn't right.
I get the correct number but in the wrong units. I got
7.848*10^-19, but I would like a explanation about why my math is
wrong. Thank you
10 cm2s ls-(100fmŕ)(1.6x10-19 C)(1.5x 1010 /crm ) lSm)(10/cm) 18 cm2s (10/m)(10"/cm) 3600 C 7848 x 10-16_ = 7848 × 10-16 (C)( 10-4cm cm 10 "(C)( m) cm 1,-0.7848x1016 A Therefore, the saturation current value is 1. 0.7848x10-16 A
10 cm2s ls-(100fmŕ)(1.6x10-19...
I am in need of help of choosing a culture to study and analyze for a project I am doing. Given the criteria (seen below), what culture would be best suited to learn more about that would be easily applicable to the questions I must answer about the culture? Criteria: Directions: Project Check List: Student will present a Power Point or Poster Presentation on a subject regarding the understanding of Cultural Awareness. Student may choose the culture of their choice....
I
got this question wrong on a quiz and I am super confused how my
answer is wrong and how I would go about getting the answer 0.1117.
If anyone could explain the process of getting that answer, it
would be very helpful! Thank you.
(Answer I submitted is outlined in red, correct answer is
below it)
The cost of off-campus living for U of O students is normally distributed. The Office of the Registrar estimates that on average it...
i am not sure about the final
answers to these questions. Including 1 and question marks
beside
Q1. (Acetic Acid CH3OOH) is monomeric in the gas phase, but forms hydrogen-bonded dimers (shown below) in the liquid and solid states. Which one of the following statements is correct? a. Stretching frequency should increase from gas to liquid/solid phases b. Stretching frequency should decrease from gas to liquid/solid phases C. C=0 Stretching frequency should not change from gas to liquid/solid phases d....
need help figuring my unknown and answering these questions
please number every question and explain...studying for exam next
week.
Transmittance 4000 3500 3000 1500 1000 2500 2000 Wavenumbers (cm-1) 500 C:47.358 H:10.598 0:42.06% N:08 X:08 0 10 Solvent We were unable to transcribe this imageMS Analysis When labeling a signal, make sure you are clear which specific one you are labeling (there may be several that are dose! When drawing a structure for a signal, draw directly on the MS...