Homework Answers
Add Answer to:
2. Three generators feed a 2-transmission line network (see below). Each component of the network is...
Consider a 2-generator power system feeding a load through transmission network as shown in Figure below....
Consider a 2-generator power system feeding a load through
transmission network as shown in Figure below. The impedance data
of the network is given in pu values on 100 MVA base. Using NR
method find the bus voltages after two i terations. The scheduled
power and nominal bus pu bus voltages are indicated in Figure
below.
Consider a 2-generator power system feeding a load through transmission network as shown in Figure 2. The impedance data of the network is given...
The one-line diagram of a simple power system is shown in Figure 1. The neutral of...
The one-line diagram of a simple power system is shown in Figure 1. The neutral of each generator is grounded through a current-limiting reactor of 0.25/3 per unit on a 100-MVA base. The system data expressed in per unit on a common 100-MVA base is tabulated below. The generators are running on no-load at their rated voltage and rated frequency with their emfs in phase. Determine the fault current for the following faults giving Zo = 0.35, Z = 0.22...
A 7-bus power system with three generators, six transformers, and seven transmission lines is shown in...
A 7-bus power system with three generators, six transformers, and seven transmission lines is shown in Figure Q1. The per-unit reactances for the generators and transfomers are based on their rated voltage and expressed in percentage. When a three-phase fault occurs at bus 5; three transmission lines, namely L4, L5, and L6, are disconnected from the power system. By taking the base apparent power of 100 MVA and the rated voltage of generator G1 as the reference, determine the per-unit...
Problem 2 (10 pts) 132 kV TL 40 km 1 pu mid-point L-E fault 60 ΛΤΑ TL: Transmission line. L-E fault: Line-to-earth fault. Z. 0.07 pu 0.1 pu Generator 0.1 pu 0.1 pu 0.1 pu Transformers 2.5x Z] Transmi...
Problem 2 (10 pts) 132 kV TL 40 km 1 pu mid-point L-E fault 60 ΛΤΑ TL: Transmission line. L-E fault: Line-to-earth fault. Z. 0.07 pu 0.1 pu Generator 0.1 pu 0.1 pu 0.1 pu Transformers 2.5x Z] Transmission Line 0.7 Ω/km 0.7 Ω/km Suppose a single L-E fault happens at the mid-point of the transmission line. Determine the per unit phase voltage and current at point P (Choose Sbase-60 MVA and Vbase-132 kV). (4 pts) * The phase impedance...
Problem #1 Part I (50 points) Consider the following one-line diagram of a three-phase power system. Assume that the system has the following base quantities: S3 100 MVA, and VbaselL 38 kV at the...
Problem #1 Part I (50 points) Consider the following one-line diagram of a three-phase power system. Assume that the system has the following base quantities: S3 100 MVA, and VbaselL 38 kV at the generator side. The rated line-to-line terminal voltage of the generator (BUS 1) is 38 kV. A single-circuit three-phase transposed overhead line composed by one ACSR Partridge conductor per phase with vertical configuration. The transmission line length is 50 km and the distance between phases a-b, b-c...
Bus A Bus B R1 TI ine 1 20% 80% line 2 T2 R2 110 kV 11 kV The fault is located at point F, which ...
Bus A Bus B R1 TI ine 1 20% 80% line 2 T2 R2 110 kV 11 kV The fault is located at point F, which is 20% of the total line 2 length from Bus B Fault MVA 1524.20471 Three-phase fault level in MVA at bus A SPFL (kA) 8 MVA1 MVA2 X1 (96 X2 (96) R1 (2) R2 (Q) z' (Q) Zo (2) Rf (Q) Single phase to ground fault level (kA) at bus A Transformer 1 MVA...
The six-bus system shown in Figure 1 will be simulated using MATLAB. Transmission line data and b...
The six-bus system shown in Figure 1 will be simulated using MATLAB. Transmission line data and bus data are given in Tables 1 and 2 respectively. The transmission line data are calculated on 100 MVA base and 230 (line-to-line) kV base for generator. Tasks: 1. Determine the network admittance matrix Y 2. Find the load flow solution using Gauss-Seidel/Newton Raphson method until first iteration by manual calculation. Use Maltab software to solve power flow problem using Gauss-Seidel method. Find the...
Power System
A simple three-phase power system is shown in Figure 2. Assume that the ratings of the various devices in this system are as follows: • Generators G1, G2: 40 MVA, 13.2 kV, = 0.15 pu, = 0.15 pu, = 0.08 • Generator G3: 60 MVA, 13.8 kV, = 0.20 pu, 0.20 pu, - 0.08 • Transformers T1, T2, T3, T4: 40 MVA, 13.8/138 kV, X1 = X2 = 0.10 pu, XO 0.08 pu Transformers T5, T6: 30 MVA, 13.8/138 kV, X1 = X2...
note that 1) single phase system 2) base values at transmission line circuit A 100 MVA,...
note that
1) single phase system
2) base values at transmission line circuit
A 100 MVA, 12 kV Single-phase generator has a sub transient reactance of 20%. The generator supplies a two synchronous motors over 25-km transmission line having transformers at both ends. The motors, all rated 6.0 kV, 66 MVA and 50 MVA for Mi and M2, respectively. For both motors X" = 15%. The single phase transformer T is rated 150 MVA, 132/12 kV with leakage reactance of...
Problem 2 (50 points): The synchronous generator shown in the figure below is operated at its rat...
Problem 2 (50 points): The synchronous generator shown in the figure below is operated at its rated apparent power (100 MVA), 0.95 pf. lagging, and 5% above rated voltage. Determine the subtransient fault current if a three phase short circuit fault occurs at the terminal of the motor (Bus 2) T1 2 100 MVA 100 MVA 13.8 kV 13.8 kV Δ/138 kVY X" = 0.15 X = 0.10 100 MVA 138 kV Y/13.8 kV Δ X0.10 100 MVA 13.8 kV...
Consider a 2-generator power system feeding a load through
transmission network as shown in Figure below. The impedance data
of the network is given in pu values on 100 MVA base. Using NR
method find the bus voltages after two i terations. The scheduled
power and nominal bus pu bus voltages are indicated in Figure
below.
Consider a 2-generator power system feeding a load through transmission network as shown in Figure 2. The impedance data of the network is given...
The one-line diagram of a simple power system is shown in Figure 1. The neutral of each generator is grounded through a current-limiting reactor of 0.25/3 per unit on a 100-MVA base. The system data expressed in per unit on a common 100-MVA base is tabulated below. The generators are running on no-load at their rated voltage and rated frequency with their emfs in phase. Determine the fault current for the following faults giving Zo = 0.35, Z = 0.22...
A 7-bus power system with three generators, six transformers, and seven transmission lines is shown in Figure Q1. The per-unit reactances for the generators and transfomers are based on their rated voltage and expressed in percentage. When a three-phase fault occurs at bus 5; three transmission lines, namely L4, L5, and L6, are disconnected from the power system. By taking the base apparent power of 100 MVA and the rated voltage of generator G1 as the reference, determine the per-unit...
Problem 2 (10 pts) 132 kV TL 40 km 1 pu mid-point L-E fault 60 ΛΤΑ TL: Transmission line. L-E fault: Line-to-earth fault. Z. 0.07 pu 0.1 pu Generator 0.1 pu 0.1 pu 0.1 pu Transformers 2.5x Z] Transmission Line 0.7 Ω/km 0.7 Ω/km Suppose a single L-E fault happens at the mid-point of the transmission line. Determine the per unit phase voltage and current at point P (Choose Sbase-60 MVA and Vbase-132 kV). (4 pts) * The phase impedance...
Problem #1 Part I (50 points) Consider the following one-line diagram of a three-phase power system. Assume that the system has the following base quantities: S3 100 MVA, and VbaselL 38 kV at the generator side. The rated line-to-line terminal voltage of the generator (BUS 1) is 38 kV. A single-circuit three-phase transposed overhead line composed by one ACSR Partridge conductor per phase with vertical configuration. The transmission line length is 50 km and the distance between phases a-b, b-c...
Bus A Bus B R1 TI ine 1 20% 80% line 2 T2 R2 110 kV 11 kV The fault is located at point F, which is 20% of the total line 2 length from Bus B Fault MVA 1524.20471 Three-phase fault level in MVA at bus A SPFL (kA) 8 MVA1 MVA2 X1 (96 X2 (96) R1 (2) R2 (Q) z' (Q) Zo (2) Rf (Q) Single phase to ground fault level (kA) at bus A Transformer 1 MVA...
The six-bus system shown in Figure 1 will be simulated using MATLAB. Transmission line data and bus data are given in Tables 1 and 2 respectively. The transmission line data are calculated on 100 MVA base and 230 (line-to-line) kV base for generator. Tasks: 1. Determine the network admittance matrix Y 2. Find the load flow solution using Gauss-Seidel/Newton Raphson method until first iteration by manual calculation. Use Maltab software to solve power flow problem using Gauss-Seidel method. Find the...
note that
1) single phase system
2) base values at transmission line circuit
A 100 MVA, 12 kV Single-phase generator has a sub transient reactance of 20%. The generator supplies a two synchronous motors over 25-km transmission line having transformers at both ends. The motors, all rated 6.0 kV, 66 MVA and 50 MVA for Mi and M2, respectively. For both motors X" = 15%. The single phase transformer T is rated 150 MVA, 132/12 kV with leakage reactance of...
Problem 2 (50 points): The synchronous generator shown in the figure below is operated at its rated apparent power (100 MVA), 0.95 pf. lagging, and 5% above rated voltage. Determine the subtransient fault current if a three phase short circuit fault occurs at the terminal of the motor (Bus 2) T1 2 100 MVA 100 MVA 13.8 kV 13.8 kV Δ/138 kVY X" = 0.15 X = 0.10 100 MVA 138 kV Y/13.8 kV Δ X0.10 100 MVA 13.8 kV...
Most questions answered within 3 hours.
-
The mean waiting time at the drive-through of a fast-food
restaurant from the time an order...
asked 6 minutes ago -
The pitch (p) of a helix is defined as p = dn, in which n is...
asked 8 minutes ago -
Do you agree that the declining stock of social capital is the
blame for the failure...
asked 12 minutes ago -
A researcher is interested in whether coffee consumption helps
with performance on reading comprehension tasks. The...
asked 22 minutes ago -
it has been estimated since the beginning of the human race that
about 133 metric ton...
asked 27 minutes ago -
Where must Medicare prescription drug plans allow for
participants to fill their prescriptions?
asked 30 minutes ago -
Five moles of monatomic ideal gas have initial pressure 2.50 ×
103 Pa and initial volume...
asked 45 minutes ago -
A resistor and the capacitor are used to control the timing in
the RC circuit of...
asked 45 minutes ago -
Living in a group could bring several disadvantages to an
individual. What are some of the...
asked 1 hour ago -
Complete and balance the following reactions. In case of no
reaction occurring write NR.
Mix #1:...
asked 1 hour ago -
If an economy consumes 75% of any increase in income, then an
increase in autonomous investment...
asked 1 hour ago -
A shotputter throws the shot with an initial speed of 15.8 m/s
at a 38.0 ∘...
asked 1 hour ago