Explain how the slew rate would affect the output of the amplifier if the input were...
Explain how the slew rate would affect the output of the amplifier if the input were a square wave where the signal switched from low to high instantaneously. Describe the output waveform.
Homework Answers
Add Answer to:
Explain how the slew rate would affect the output of the
amplifier if the input were...
a The operational amplifier in Figure 3.a has a slew rate of 0.5V/us and a unity gain bandwid of 5 MHz. Determine () the voltage gain, and (ii) the maximum input frequency such that the output wa...
a The operational amplifier in Figure 3.a has a slew rate of 0.5V/us and a unity gain bandwid of 5 MHz. Determine () the voltage gain, and (ii) the maximum input frequency such that the output waveform is undistorted. with Vpeak 1V and frequency f. () Determine the cutoff frequency, (ii) plot, to scale, the you use this integrator if the input frequency is 30 KHz? Explain your answer. that any feedback resistance is fixed to 5k2. b. In the...
And b. slew lall unity-gain frequency amplifier. Specifications require that the gain vary no mor...
4-47
ans:
a. 11.77Mhz
b. 40.21V/ms
c. yes
and b. slew lall unity-gain frequency amplifier. Specifications require that the gain vary no more than 2 dB from near The peak input signal is estimated as 0.8 V. Determine the minimum values of frequency and b. slew rate for the op-amp selected. c. Would the LM1182181 4-47. An inverting amplifier with a gain of -8 is to be designed for use in a s de to 1 MHz. a. unity-gain op-amp...
Please select the correct statements: The bandwidth of a circuit can be found by measuring the 5/7 drop in output signal The input impedance of a circuit can be found by adding a resistor in parallel...
Please select the correct statements: The bandwidth of a circuit can be found by measuring the 5/7 drop in output signal The input impedance of a circuit can be found by adding a resistor in parallel and measuring the change in voltage The X-Y mode on the scope shows the phase difference and distortion between two inputs E12 resistors have +/-10% tolerence. Typical values are: 100, 1k, 1.5k, 2k Ohm An voltage follower op-amp with a slew rate of 1V/ms...
Laboratory 1: operation amplifier characteristics A. Objectives: 1. To study the basic characteri...
thanks
Laboratory 1: operation amplifier characteristics A. Objectives: 1. To study the basic characteristics of an operational amplifier 2. To study the bias circuit of an operational amplifier B. Apparatus: 1. DC Power supply 2. Experimental board and corresponding components 3. Electronic calculator (prepared by students) 4. Digital camera (prepared by students for photo taking of the experimental results) 5. Laptop computer with the software PicoScope 6 and Microsoft Word installed. 6. PicoScope PC Oscilloscope and its accessories. 7. Multimeter...
5. a) What are the pros and cons of a sine wave PWM inverter versus a plain square wave inverter?...
5. a) What are the pros and cons of a sine wave PWM inverter versus a plain square wave inverter? b) Sketch a block diagram ofa Class D audio amplifier, and briefly explain how it is related to a PwM sine wave inverter and amplifies an input audio signal. c) Suppose we have a single tone audio signal of frequency, 10 KHz, and the carrier frequency is 100 KHz. Sketch the approximate power spectrum of the output waveform. Does the...
What is low-voltage low-power differential-input single-ended output amplifier? How to design it?
What is low-voltage low-power differential-input single-ended output amplifier? How to design it?
A. (10 pts) Implement the voltage amplifier shown below using an ideal op amp circuit. You have o...
a. (10 pts) Implement the voltage amplifier shown below using an ideal op amp circuit. You have one op amp available for this circuit, and a range of resistors with values from 1 kΩ to 100 ka. Draw the schematic of your op amp circuit, labeling resistor values. Make sure the gain, input resistance, and output resistance of your circuit matches the model in the schematic. R=012 *100v, RL 100 b. (5 pts) Your amplifier circuit should have a frequency...
3. Let Vi is AC input signal which has following properties: Voffset: 1 Volt Vpp: 0.5 Volt Wavefo...
3. Let Vi is AC input signal which has following properties: Voffset: 1 Volt Vpp: 0.5 Volt Waveform: Sinus Frequency: 1 KHz a) Why we chose 1 Volt for offset voltage? b) If the waveform is Square, what would happens in terms of circuit characteristics? How do you make AC Analysis of the circuit to calculate expected output signal? Please explain as step by step. R2-820 0 c) (NPN) R1-100 Figure 1. A transistor circuit
3. Let Vi is AC...
How does the household savings rate affect the impact on output of an increase in government...
How does the household savings rate affect the impact on output of an increase in government spending? If the rate of savings is low, the effect of the increase will be greater than it otherwise would have been. If the rate of savings is high, the effect of the increase will be greater than it otherwise would have been. If the increase in government spending is high, the effect will be large. It has no effect. An increase in taxes...
Part I: Black Box A Design your first black box adhering to the following specifications A. Input Signal to Black Box A 1. A 1 kHz cosine wave with amplitude of 1V. B. Output Signal from Black Box A...
Part I: Black Box A Design your first black box adhering to the following specifications A. Input Signal to Black Box A 1. A 1 kHz cosine wave with amplitude of 1V. B. Output Signal from Black Box A 1. A 1 kHz sine wave with amplitude of Hint: Use an ideal op-amp C. Explain your design process. What type of circuit did you design? Discuss D. Why did vou use an op-amp? Could another component be used instead? Why...
a The operational amplifier in Figure 3.a has a slew rate of 0.5V/us and a unity gain bandwid of 5 MHz. Determine () the voltage gain, and (ii) the maximum input frequency such that the output waveform is undistorted. with Vpeak 1V and frequency f. () Determine the cutoff frequency, (ii) plot, to scale, the you use this integrator if the input frequency is 30 KHz? Explain your answer. that any feedback resistance is fixed to 5k2. b. In the...
4-47
ans:
a. 11.77Mhz
b. 40.21V/ms
c. yes
and b. slew lall unity-gain frequency amplifier. Specifications require that the gain vary no more than 2 dB from near The peak input signal is estimated as 0.8 V. Determine the minimum values of frequency and b. slew rate for the op-amp selected. c. Would the LM1182181 4-47. An inverting amplifier with a gain of -8 is to be designed for use in a s de to 1 MHz. a. unity-gain op-amp...
Please select the correct statements: The bandwidth of a circuit can be found by measuring the 5/7 drop in output signal The input impedance of a circuit can be found by adding a resistor in parallel and measuring the change in voltage The X-Y mode on the scope shows the phase difference and distortion between two inputs E12 resistors have +/-10% tolerence. Typical values are: 100, 1k, 1.5k, 2k Ohm An voltage follower op-amp with a slew rate of 1V/ms...
thanks
Laboratory 1: operation amplifier characteristics A. Objectives: 1. To study the basic characteristics of an operational amplifier 2. To study the bias circuit of an operational amplifier B. Apparatus: 1. DC Power supply 2. Experimental board and corresponding components 3. Electronic calculator (prepared by students) 4. Digital camera (prepared by students for photo taking of the experimental results) 5. Laptop computer with the software PicoScope 6 and Microsoft Word installed. 6. PicoScope PC Oscilloscope and its accessories. 7. Multimeter...
5. a) What are the pros and cons of a sine wave PWM inverter versus a plain square wave inverter? b) Sketch a block diagram ofa Class D audio amplifier, and briefly explain how it is related to a PwM sine wave inverter and amplifies an input audio signal. c) Suppose we have a single tone audio signal of frequency, 10 KHz, and the carrier frequency is 100 KHz. Sketch the approximate power spectrum of the output waveform. Does the...
a. (10 pts) Implement the voltage amplifier shown below using an ideal op amp circuit. You have one op amp available for this circuit, and a range of resistors with values from 1 kΩ to 100 ka. Draw the schematic of your op amp circuit, labeling resistor values. Make sure the gain, input resistance, and output resistance of your circuit matches the model in the schematic. R=012 *100v, RL 100 b. (5 pts) Your amplifier circuit should have a frequency...
3. Let Vi is AC input signal which has following properties: Voffset: 1 Volt Vpp: 0.5 Volt Waveform: Sinus Frequency: 1 KHz a) Why we chose 1 Volt for offset voltage? b) If the waveform is Square, what would happens in terms of circuit characteristics? How do you make AC Analysis of the circuit to calculate expected output signal? Please explain as step by step. R2-820 0 c) (NPN) R1-100 Figure 1. A transistor circuit
3. Let Vi is AC...
Part I: Black Box A Design your first black box adhering to the following specifications A. Input Signal to Black Box A 1. A 1 kHz cosine wave with amplitude of 1V. B. Output Signal from Black Box A 1. A 1 kHz sine wave with amplitude of Hint: Use an ideal op-amp C. Explain your design process. What type of circuit did you design? Discuss D. Why did vou use an op-amp? Could another component be used instead? Why...
Most questions answered within 3 hours.
-
Consider the following reaction at equilibrium. What will happen
if O2 is added to the reaction?...
asked 55 minutes ago -
Based on how much or how little you have noticed in the media,
do you think...
asked 3 hours ago -
I calculate Rosetta Stone’s P/E ratio as 10x prior to a report
about future industry growth....
asked 4 hours ago -
What major physiological changes account for electrodermal
activity (as in during a lie-detector test)?
asked 5 hours ago -
You are going to sell fruits & vegetables at a local
roadside market. List separately and...
asked 6 hours ago -
Hows does water affect the digestion of fats ?
asked 8 hours ago -
A buffer that contains 0.41 M of a base, B and 0.21 M of its
conjugate...
asked 8 hours ago -
Pleaaaaaaaasssssse help me please please it's more important
:((((((((((((((((((((
CASE STUDY
Nissan Company
Nissan Motor Company,...
asked 8 hours ago -
Calculate the concentration of hydronium and hyroxide ions in 1)
2.0 mol/L HNO3 2) 0.5 mol/L...
asked 9 hours ago -
In a loop-the-loop ride a car goes around a vertical, circular
loop at a constant speed....
asked 9 hours ago -
50 grams each of water (18.015 g/mol) and ethylene glycol
(C2H6O2) (62.07 g/mol) are mixed. At...
asked 9 hours ago -
The life expectancy of sport utility vehicles follows a normal
distribution with a mean of 145.8...
asked 9 hours ago