4- A freezing room maintained at -25 oC. Beef of 30 ton at 15 oC to...
Problem 4: Heat Exchangers Analysis (25 points) A counterflow plate-type heat exchanger as shown in the figure below is used to cool propane fuel W 50 mm H 25 mm Saturated Vapor propane Thickness t =5 mm H 25 mm Cooling water Length L The flow rate of the cooling water is 0.2 kg/s, while the flow of the propane is 0.1 kg/s. The water enters the heat exchanger at a temperature of 20°C while the propane enters at its...
(25 pts) A well-insulated and well-sealed 2-m x 3-m x 4-m room is initially at Tal = 22 °C and p = 100 kPa. A mass of mw = 20 kg of liquid water at Tw./ = 80 °C is brought into the room and the system is allowed to reach equilibrium conditions (state 2). 2m x 3m x 4m ROOM 22°C 100 kPa Specific heat values for the air and water may be taken as Cp,air = 1.005 kJ/kg-K;...
2). A hydrocarbon fluid is to be cooled from 90 to 15 C at a rate of 9.72 ton per hr. pass shell and tube heat exchanger with the following specification is available A single- Number of tubes 250 1.0 m 23.5 mm 25 mm 15 W m- K-I Tube length Internal tube diameter External tube diameter Thermal conductivity of tube wall Chilled water is supplied at 4C and is normally discharged at 10 C. From experience it is assumed...
Design Problem Design a small chiller room 2.35 m wide by 6 m long and 2.38 m high that is to be used to chill and store a food product. The chiller is to be loaded with 60 buckets of the food product at 23 °C which needs to be cooled down to 3 °C within 24 hours using air at 1 °C, with a heat transfer coefficient of 36 W m2 K Tasks 1. Calculate the peak refrigeration loading...
System Model: Automotive Air Conditioning System Outside Air Temp: 45 oC Car Interior Air Temp: 22 oC Heat Load = 4.2 kJ/sec rate at which heat must go in to the air conditioner to be removed from the car’s interior Refrigerant: R134a HINT: Heat enters an air conditioning system where? Refrigerant 134a … - leaves the evaporator coil and enters the compressor as a saturated vapor at the evaporator pressure of 2.8 bars. - It leaves the compressor at...