Design a single-sideband AM modulator and demodulator units based on following rules. Bandwidth of filter you...
Design a single-sideband AM modulator and demodulator units based on following rules.
Bandwidth of filter you will design will be 6kHz in case of double sideband solutions
Carrier frequency will be 4MHz.
Determine the values of elements (if any; R, C, and L) used in the circuits.
Homework Answers
Add Answer to:
Design a single-sideband AM modulator and demodulator units
based on following rules.
Bandwidth of filter you...
Design a narrow band FM modulator and demodulator units based on the following rules. By using...
Design a narrow band FM modulator and demodulator units based on the following rules. By using your design, assume that you are planning to broadcast music and listen to it. Design Principles 1. Bandwidth of the message signal is 4kHz. II. Carrier frequency is 50MHz III. Allowable maximum frequency deviation in the system is 50kHz. a) Determine the values of elements (if any; R. C, and L) used in the circuits. b) In case of noise (N. = 2x10-8W.Hz-1) added...
[15 points] You are asked to design a DSB-SC AM modulator to generate a modulated signal km(t)cos...
[15 points] You are asked to design a DSB-SC AM modulator to generate a modulated signal km(t)cos(wt+0), where m(t) is a signal band-limited to B Hz. The following figure shows a DSB- SC AM modulator available in the stockroom. The carrier generator available generates not cos(wct), but cos (wct). Explain whether you would be able to generate the desired signal using only this equipment. You may use any kind of filter you like. 3. What kind of filter is required...
3.2 Simple Bandpass Filter Design The L-point averaging filter is a lowpass filter. Its passband width...
3.2 Simple Bandpass Filter Design The L-point averaging filter is a lowpass filter. Its passband width is controlled by L, being inversely proportional to L. In fact, you can use the GUI altidemo to view the frequency response for different averagers and measure the passband widths. It is also possible to create a filter whose passband is centered around some frequency other than zero. One simple way to do this is to define the impulse response of an L-point FIR...
Learning Goal: To analyze and design a passive, second-order bandpass filter using a series RLC circuit....
Learning Goal: To analyze and design a passive, second-order bandpass filter using a series RLC circuit. A bandpass filter is needed for an equalizer, a device that allows one to select the level of amplification of sounds within a specific frequency band while not affecting the sounds outside that band. The filter should block frequencies lower than 1.8 kHz and have a resonant frequency of 5.4 kHz A 3.2 AF capacitor and any needed resistors and inductors are available to...
A common source amplifier circuit based on a single n-channel MOSFET is shown in Figure 4b. Assume that the transconductance gm-60 mS (equivalent to mA/ V) and drain source resistance, os,...
A common source amplifier circuit based on a single n-channel MOSFET is shown in Figure 4b. Assume that the transconductance gm-60 mS (equivalent to mA/ V) and drain source resistance, os, is so large it may be neglected. 0) Calculate the open circuit voltage gain Av Yout/ Vis. i) The amplifier has a load of 10 k2. Determine the current gain Va. = 12 V 150k 4k3 Vout Vin 200k GND = 0 V Figure 4b a) State the name...
I only need help with the discussion there are many info that you do not need put I put just in ...
I only need help with the discussion
there are many info that you do not need put I put just in
case as well as my data table.
please do it as soon as u can
Meauements ODeit1 Check2 Meaurements Checi3 Ced Check5 Check6 Measurements Check7 heck8 4058 33 536 1502 1035 979 119478 041 1.0319|0.554972| 64261| 153|15542033681 995781 5266566 1578807 298h 1631 119 1209430016 079096812 0.418135246 0,00032665 011890:004668155728441 0293237 1.291809502 1.22833 1.28 1952 -1116 4281 140616885511984206317 3346 8162 0.78...
PLEASE SOLVE THESE PROBLEMS! URGENT 8/16/2019 How to Recognize Plagiarism -- Undergraduate Certification Tests : School...
PLEASE SOLVE THESE PROBLEMS! URGENT
8/16/2019 How to Recognize Plagiarism -- Undergraduate Certification Tests : School of Education, Indiana University Bloomington In the case below, the original source material is given along with a View Site sample of student work. Determine the type of plagiarism by clicking Map the appropriate radio button. Original Source Material Student Version Acknowledge Site Suppose you study a group of successful companies and you find that they emphasize customer focus, or quality improvement, or empowerment;...
summatize the following info and break them into differeng key points. write them in yojr own...
summatize the following info and break them into differeng key points. write them in yojr own words
apartus
6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
Article Summary I Read the article below and provide feedback by writing a 2 page summary....
Article Summary I Read the article below and provide feedback by writing a 2 page summary. Please write in essay format (you may include the questions but the response should be in essay format) Must include the following information Title of the article Author(s) of the article Reference list (include the article itself and any other reference material such as another article that is cited in your summary). Use the reference list in the article to get information about another...
[15 points] You are asked to design a DSB-SC AM modulator to generate a modulated signal km(t)cos(wt+0), where m(t) is a signal band-limited to B Hz. The following figure shows a DSB- SC AM modulator available in the stockroom. The carrier generator available generates not cos(wct), but cos (wct). Explain whether you would be able to generate the desired signal using only this equipment. You may use any kind of filter you like. 3. What kind of filter is required...
3.2 Simple Bandpass Filter Design The L-point averaging filter is a lowpass filter. Its passband width is controlled by L, being inversely proportional to L. In fact, you can use the GUI altidemo to view the frequency response for different averagers and measure the passband widths. It is also possible to create a filter whose passband is centered around some frequency other than zero. One simple way to do this is to define the impulse response of an L-point FIR...
Learning Goal: To analyze and design a passive, second-order bandpass filter using a series RLC circuit. A bandpass filter is needed for an equalizer, a device that allows one to select the level of amplification of sounds within a specific frequency band while not affecting the sounds outside that band. The filter should block frequencies lower than 1.8 kHz and have a resonant frequency of 5.4 kHz A 3.2 AF capacitor and any needed resistors and inductors are available to...
A common source amplifier circuit based on a single n-channel MOSFET is shown in Figure 4b. Assume that the transconductance gm-60 mS (equivalent to mA/ V) and drain source resistance, os, is so large it may be neglected. 0) Calculate the open circuit voltage gain Av Yout/ Vis. i) The amplifier has a load of 10 k2. Determine the current gain Va. = 12 V 150k 4k3 Vout Vin 200k GND = 0 V Figure 4b a) State the name...
I only need help with the discussion
there are many info that you do not need put I put just in
case as well as my data table.
please do it as soon as u can
Meauements ODeit1 Check2 Meaurements Checi3 Ced Check5 Check6 Measurements Check7 heck8 4058 33 536 1502 1035 979 119478 041 1.0319|0.554972| 64261| 153|15542033681 995781 5266566 1578807 298h 1631 119 1209430016 079096812 0.418135246 0,00032665 011890:004668155728441 0293237 1.291809502 1.22833 1.28 1952 -1116 4281 140616885511984206317 3346 8162 0.78...
PLEASE SOLVE THESE PROBLEMS! URGENT
8/16/2019 How to Recognize Plagiarism -- Undergraduate Certification Tests : School of Education, Indiana University Bloomington In the case below, the original source material is given along with a View Site sample of student work. Determine the type of plagiarism by clicking Map the appropriate radio button. Original Source Material Student Version Acknowledge Site Suppose you study a group of successful companies and you find that they emphasize customer focus, or quality improvement, or empowerment;...
summatize the following info and break them into differeng key points. write them in yojr own words
apartus
6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
Most questions answered within 3 hours.
-
Given that a sample of aluminium oxide has a Young's modulus of
393 GPa and a...
asked 1 hour ago -
At a certain temperature, the equilibrium constant, Kc, for this
reaction is 53.3.
H2(g)+I2(g)−⇀↽−2HI(g)Kc=53.3
At this...
asked 2 hours ago -
Question1 ) The STL provides similiar classes called stack and
queue, both of which gave functions...
asked 3 hours ago -
For Questions 1-4, assume you have 5 bits available:
1. For (positive) integers: What is the...
asked 3 hours ago -
convert grams into vloume with the density of water being at
.997514 g/cm^3 at 23.1 Celsuis...
asked 5 hours ago -
Foreman company obtained a $20,000, 6% loan on May 1, 2018.
Principal and interest will be...
asked 5 hours ago -
5. Problem 11.05 (Discounted Payback)
eBook
Project L costs $60,000, its expected cash inflows are $14,000
per...
asked 6 hours ago -
1. Which of the following is true about politics and health
organizations?
A. Health organizations are...
asked 6 hours ago -
A space vehicle is coasting at a constant velocity of 18.1 m/s
in the +y direction...
asked 7 hours ago -
5) Use the following balanced equation to answer questions
(a)-(i).
3 Cu(s) + 8 HNO3(aq) →...
asked 7 hours ago -
A three-year maturity bond with a 12% annual coupon rate is
currently traded at par $1000...
asked 7 hours ago -
1.
What is the minimum volume to use in the Spec 20 cuvette in order
to...
asked 8 hours ago