Homework Answers
Add Answer to:
Question: Show that the time instants the diode turns on and off are given by ton...
Question 1: An ideal diode turns on for positive anode-cathode voltages. But the characteristic of diode...
Question 1: An ideal diode turns on for positive anode-cathode voltages. But the characteristic of diode does not appear to show any ID values when voltage across the diode is greater than zero (VD > 0). How do you explain this plot? ---Reverse bias Forward bias --- Question 2: Plot (I-V) characteristic if we place a 10 12 resistor in series with the diode? Question 3: Plot (I-V) characteristic if we place a lV voltage source in series with the...
ng off a long time. Find 6) For the following circuit, the voltage source turns on...
ng off a long time. Find 6) For the following circuit, the voltage source turns on a time zero after bei (a) at t 0+ the inductor current i(O+) and its rate of change, (b) at t = 0+ the capacitor voltage vo-) and its rate of change, du (Do not write a differential equation or solve for voltage or current as functions of time.) dt t0+ 4012 10.2 211(1) A 10u() V tz 0 lot) 1O Carm
QUESTION 1 In the diode circuit shown aside, given that V1 = V2 = 2.7 V,...
QUESTION 1 In the diode circuit shown aside, given that V1 = V2 = 2.7 V, R = 1 k12 R2 = 2 kn, R3 = 4k and assuming constant-voltage-drop diode model (Vo = 0.7 V), determine the voltage drop (V) across the resistor R1, if the switch (S) is connected to a. Position 1 b. Position 2 V = Na V2
Use matlab to solve Project A half-wave diode rectifier shown in the following Fig. 1 is...
Use matlab to solve
Project A half-wave diode rectifier shown in the following Fig. 1 is an electrical cirouit that coeverts AC voltage to DC voltage. The voltage of the source is y,Sin(utwhere -f in whicfis the frequency. The operation of the circuit is illustrated in Fig. 2 where the dashod line shows the source veltage and the solid line shows the voltage across the resistor Diode Time Fig. 1 In the first cycle, thediode is on (conductingcurrent)fromに0umi 4Atthstme thediodetums...
Question 4 (15 marks) Figure 4 shows a single-phase diode bridge rectifier supplied from the 230...
Question 4 (15 marks) Figure 4 shows a single-phase diode bridge rectifier supplied from the 230 V, 50 Hz mains via a step- down transformer D2 D SW + n: 1 + 230 V 33mF 20 0 Vo 50 Hz D3 D4 Figure 4 (a) Assuming that the switch SW is open, explain the operation of the rectifier in figure 4 with the aid of the waveforms of the input and output voltages (v, and v) [4 marks (b) With...
Given: vi -35 sin(t) and +V+15 volts. C is very large. The diode ideal. The circuit...
Given: vi -35 sin(t) and +V+15 volts. C is very large. The diode ideal. The circuit has been running for a long time. Sketch a cycle or two of vi and voshowing maximum, minimum and average values. Hint: the large capacitor will act like a DC voltage source. Vi
Ctri Question 3 (20 Marks) Lab 1-Zener Circuits and Applications Theory: Zener diode is designed ...
Ctri Question 3 (20 Marks) Lab 1-Zener Circuits and Applications Theory: Zener diode is designed to operate in reverse conduction. Zener breakdown occurs at a precisely defined voltage, allowing the diode to be used as a voltage reference or clipper. While Zener diodes are usually operated in reverse conduction, they may also be operated in cutoff and forward conduction. There are two different effects that are used in "Zener diodes". The only practical difference is that the two types have...
Show all steps please (I have the answers I need the steps Question 1: 20% Given...
Show all steps please (I have the answers I need the
steps
Question 1: 20% Given that a silicon PN junction diode (D1) has forward current of 1.5 mA at forward voltage of 0.7V, thermal voltage V-26mV at room temperature. Assuming diode forward and reverse characteristic is given by: Forward equation: izle , Reverse cquation: i=-1 (a) Find reverse saturation current Is parameter. (3%) i= Isere =1.5m = Is e 2026 Is = 3.04x107S A (f) A 0.? (a) Find...
Problem 1: Signal conditioning and ADC Given the measurement of voltage sensor in the first 20 ms that involving a seve...
Problem 1: Signal conditioning and ADC Given the measurement of voltage sensor in the first 20 ms that involving a several noises causes a drift in measurement. The measurement signal fluctuates with time as a sine wave [sin(wt), ω in rad/s, t in ms] which can be approximately divided into four sections as in the following table Section I Section II on III 9St<13.2 Section IV Time (ms)OSt<5.5 Signal (volt) V-0.5+0.1 5.5 St<9 13.2 Sts20.5 V-0.6+0.1 V-0.55+0.1 V-0.65+0.1 sin(3.41x 103t)...
32. A transformer is to be designed to increase the 30 kV-rms output of a generator...
32. A transformer is to be designed to increase the 30 kV-rms output of a generator to the transmission-line voltage of 345 kV-om. If the primary winding has 80 turns, how many turns must the secondary have? b. 70 c. 920 d. 9200 e 12 33. The primary winding of an electric train transformer has 400 turns and the Secondary has 50. If the input voltage is 120V(rms) what is the output voltage? a. 15 V (rms) b. 30 Vrms)...
Question 1: An ideal diode turns on for positive anode-cathode voltages. But the characteristic of diode does not appear to show any ID values when voltage across the diode is greater than zero (VD > 0). How do you explain this plot? ---Reverse bias Forward bias --- Question 2: Plot (I-V) characteristic if we place a 10 12 resistor in series with the diode? Question 3: Plot (I-V) characteristic if we place a lV voltage source in series with the...
ng off a long time. Find 6) For the following circuit, the voltage source turns on a time zero after bei (a) at t 0+ the inductor current i(O+) and its rate of change, (b) at t = 0+ the capacitor voltage vo-) and its rate of change, du (Do not write a differential equation or solve for voltage or current as functions of time.) dt t0+ 4012 10.2 211(1) A 10u() V tz 0 lot) 1O Carm
QUESTION 1 In the diode circuit shown aside, given that V1 = V2 = 2.7 V, R = 1 k12 R2 = 2 kn, R3 = 4k and assuming constant-voltage-drop diode model (Vo = 0.7 V), determine the voltage drop (V) across the resistor R1, if the switch (S) is connected to a. Position 1 b. Position 2 V = Na V2
Use matlab to solve
Project A half-wave diode rectifier shown in the following Fig. 1 is an electrical cirouit that coeverts AC voltage to DC voltage. The voltage of the source is y,Sin(utwhere -f in whicfis the frequency. The operation of the circuit is illustrated in Fig. 2 where the dashod line shows the source veltage and the solid line shows the voltage across the resistor Diode Time Fig. 1 In the first cycle, thediode is on (conductingcurrent)fromに0umi 4Atthstme thediodetums...
Question 4 (15 marks) Figure 4 shows a single-phase diode bridge rectifier supplied from the 230 V, 50 Hz mains via a step- down transformer D2 D SW + n: 1 + 230 V 33mF 20 0 Vo 50 Hz D3 D4 Figure 4 (a) Assuming that the switch SW is open, explain the operation of the rectifier in figure 4 with the aid of the waveforms of the input and output voltages (v, and v) [4 marks (b) With...
Given: vi -35 sin(t) and +V+15 volts. C is very large. The diode ideal. The circuit has been running for a long time. Sketch a cycle or two of vi and voshowing maximum, minimum and average values. Hint: the large capacitor will act like a DC voltage source. Vi
Ctri Question 3 (20 Marks) Lab 1-Zener Circuits and Applications Theory: Zener diode is designed to operate in reverse conduction. Zener breakdown occurs at a precisely defined voltage, allowing the diode to be used as a voltage reference or clipper. While Zener diodes are usually operated in reverse conduction, they may also be operated in cutoff and forward conduction. There are two different effects that are used in "Zener diodes". The only practical difference is that the two types have...
Show all steps please (I have the answers I need the
steps
Question 1: 20% Given that a silicon PN junction diode (D1) has forward current of 1.5 mA at forward voltage of 0.7V, thermal voltage V-26mV at room temperature. Assuming diode forward and reverse characteristic is given by: Forward equation: izle , Reverse cquation: i=-1 (a) Find reverse saturation current Is parameter. (3%) i= Isere =1.5m = Is e 2026 Is = 3.04x107S A (f) A 0.? (a) Find...
Problem 1: Signal conditioning and ADC Given the measurement of voltage sensor in the first 20 ms that involving a several noises causes a drift in measurement. The measurement signal fluctuates with time as a sine wave [sin(wt), ω in rad/s, t in ms] which can be approximately divided into four sections as in the following table Section I Section II on III 9St<13.2 Section IV Time (ms)OSt<5.5 Signal (volt) V-0.5+0.1 5.5 St<9 13.2 Sts20.5 V-0.6+0.1 V-0.55+0.1 V-0.65+0.1 sin(3.41x 103t)...
32. A transformer is to be designed to increase the 30 kV-rms output of a generator to the transmission-line voltage of 345 kV-om. If the primary winding has 80 turns, how many turns must the secondary have? b. 70 c. 920 d. 9200 e 12 33. The primary winding of an electric train transformer has 400 turns and the Secondary has 50. If the input voltage is 120V(rms) what is the output voltage? a. 15 V (rms) b. 30 Vrms)...
Most questions answered within 3 hours.
-
Your child is planning attend summer camp for three months,
starting 7 months from now. The...
asked 3 minutes ago -
asssume you are the employee representative on the executive
board at your company. You know the...
asked 7 minutes ago -
If you have all the letters of the alphabet spread on a table.
How many different...
asked 9 minutes ago -
Tree Seedlings has the following current-year purchases and
sales for its only product. Date Activities Units...
asked 6 minutes ago -
Monopoly pricing 4. Firm X has a complete monopoly over the
production of nutmeg. The following...
asked 8 minutes ago -
What is the momentum (in MeV/c) and kinetic energy of a proton
with a total energy...
asked 9 minutes ago -
a 1.2-cm-diameter solenoid passing through the center of a
7.0-cm-diameter loop. The magnetic field inside the...
asked 24 minutes ago -
One of the difficulties in geolocational profiling plant-derived
drugs is obtaining reliable standards. Elaborate on this...
asked 45 minutes ago -
An animal whose limb temperature is colder compared to the core
is displaying....
d. counter current...
asked 45 minutes ago -
Find the expected value E(X), the variance Var(X) and the
standard deviation σ(X) for each of...
asked 1 hour ago -
home / study / science / physics / physics questions and answers
/ 2. an object...
asked 1 hour ago -
What do you think every computer science department must teach,
concerning the fact that technology rapidly...
asked 1 hour ago