in adsorber column, why there are two supporting ball layers (one at the top, one at...

Question

Question

in adsorber column, why there are two supporting ball layers (one at the top, one at the bottom). Shouldn't it be only one, near feed inlet?

Answer 1

Answer #1

Answer 2

Similar Homework Help Questions

QUESTION 5 A distillation column has one inlet feed (F), and two outlets, a distillate (D)...

QUESTION 5 A distillation column has one inlet feed (F), and two outlets, a distillate (D) and a bottom (B) stream. The inlet feed, F = 100 kg/h, of ethanol and water, has an ethanol mass fraction of xF = 0.5. The distillate flow rate is 85 kg/h, and the bottom ethanol mass fraction is xB = 0.38. What is the total bottom flow rate, B, in kg/h?
Please show all work, thank you! A one toil column is being set in place by...

Please show all work, thank you! A one toil column is being set in place by two 5 degree wedges as shown. If the coefficient of friction between all surfaces of the wedges is 0.20 and the coefficient of friction for the screw is 0.40, calculate the torque necessary to lift the column. Neglect friction between the screw and the wedge and between the left face of the wedge and the bracket. Consider that friction acts only on the top...
A student drops two ball bearings, a lighter one and a heavier one, from a top...

A student drops two ball bearings, a lighter one and a heavier one, from a top of a roof. The friction is insignificant. Just before hitting the ground, the heavier ball has twice the kinetic energy. How much faster did it go? so to do this I just did. KE = 1/2 m V^2 2KE = mv^2 so 0.5 faster?

1. Column is simple supported at both ends and subjected to two compressive forces: one is...

1. Column is simple supported at both ends and subjected to two compressive forces: one is acting at the top end and one is applied at the distance a from the bottom. The total length of the cokumn is I, moment of inertia I, Young;s modulus is E. Derive formula for the critical buckling sum of these two forces P R+P2 2 2. Aluminum rectangular prism is put between two rigid walls and loaded by compressive pressure p applied on...
PLz Consider the two small, equal-mass, charged balls shown in the figure. The top ball is...

PLz Consider the two small, equal-mass, charged balls shown in the figure. The top ball is suspended from the ceiling by a filament, and has a charge of q129.0 nC. The bottom ball has a charge of q2-_58.0 nC, and is directly below the top ball. Assume d 2.00 cm and m 6.40 9- m@-L 12 (a) Calculate the tension (in N) in the filament. 025 N (b) If the filament can withstand a maximum tension of 0.180 N, what...
The top two layers of NCAA governance consist of Group of answer choices conference commissioners athletics...

The top two layers of NCAA governance consist of Group of answer choices conference commissioners athletics directors university presidents faculty athletics representatives NCAA staffers

Problem#2 A W12 x58, A992 column is pinned at the top and fixed at the bottom...

Problem#2 A W12 x58, A992 column is pinned at the top and fixed at the bottom as shown. Lateral bracing is provided to assist with weak-axis buckling strength 12.5 ft from the ground level. For the condition where the column only supports axial load, determine the design strength of the column. K 1.0 7.5 ft K- 0.8 20 ft K = 0.8 | 12.5 ft
A site is underlain by two layers of normally consolidated clayey sand. The unit weights of...

A site is underlain by two layers of normally consolidated clayey sand. The unit weights of the top layer are 19 and 21 kN/m3 and the layer is 6 meters thick. The unit weights of the bottom layer are 20 and 22 kN/m3 and the layer is 8 meters thick. Below the bottom layer lies bedrock. The water table is located 2 meters below the ground surface. The top layer soil has an effective stress friction angle of 38 degrees,...
The four cases below all show a ball with a charge of −3q at the top...

The four cases below all show a ball with a charge of −3q at the top right corner of a square. Then there is either one, two, or three additional charged balls, each ball located at a different corner of the square. (b) In Case D, calculate the magnitude of the net electric field at the center of the square. (c) In Case A, calculate the magnitude of the net electric field at the bottom left corner of the square....

A ball is dropped from rest from the top of a building. Two motion detectors which...

A ball is dropped from rest from the top of a building. Two motion detectors which are positioned outside of two different windows, one above the other, record the velocities of -15.5 m/s and -17.2 m/s as the ball goes past them. (no air resistance) a. How far apart are the motion sensors mounted? b. How far from the top motion sensor is the top of the building where the ball was released? c. If the second motion sensor can...