Write the equation to calculate design shear stress (longitudinal) and briefly explain the parameters with diagram.
Write the equation to calculate design shear stress (longitudinal) and briefly explain the parameters with diagram.
(a) Briefly explain Mohr-Coulomb theory and show how we can determine the shear strength parameters of soil by plotting the shear stress versus normal stress. [3 marks] The following results were obtained from a consolidated undrained Triaxial (CU) test with pore water pressure measurement on three samples of a fully saturated clay. Determine the total (undrained) stress and effective (drained) stress parameters. [12 marks] Sample Cell pressure (kN/m2) Deviator stress at failure (kN/m2) Pore pressure at failure (kN/m2) A 300...
Combined shear stress includes: Longitudinal Shear Torsion Bending Shear O Transverse Shear Question 39 In the hoop stress calculation, "p" corresponds to: O pressure in the walls of the tank o distance p from the center O pressure in the tank Question 40 The 3D state of stress for a cubic element has how many stress components on each face? O 6 O2 03 Question 41 What angle is an element rotated from the position that results in maximum principal...
show the shear and moment diagram and solve normal stress, bending stress and shear stress. Please show every step in details.
In the design of the beam shown below, the shear stress is to be found in MPa. Calculate the shear stress to 2 decimal places of the beam below given allowable shear stress Tallow = 85 MPa and the W-section is made with d=313 mm and tw=6.6 mm. -2 m 2 m
In the design of the beam shown below, the shear stress is to be found in MPa. Calculate the shear stress to 2 decimal places of the beam below given allowable shear stress Tallow = 85 MPa and the W-section is made with d=313 mm and tw=6.6 mm. -2 m- 2 m P
Problem 1: Calculate the resolved shear stress acting on the (101) [111] system for a single crystal of BCC molybdenum subject to the following: • Applied stress: 55 MPa • Direction of applied stress: [001] (a) Sketch the direction of applied stress in the cubic cell diagram on the right: (b) Use the cubic cell diagram on the diagram on the right to sketch: • The slip plane • The slip direction (c) Determine the indices for the direction normal...
What is shear stress proportional to when applied to a fluid? Write the expression for shear stress. What is cavitation? Give an example of when this can occur. HTML Editor Explain water hammer. Provide an example. What is the difference between laminar and turbulent flow? What nondimensional parameter is used to determine if the flow is laminar or turbulent? (Hint: Ratio of inertial forces to viscous forces).
uniformly varying load find shear force diagram and beding moment diagram. may you explain the equation that produces the 4.33 value? thanks 12 kip akip -4.33 26.67 kip 37.33kip
Learning Goal: To calculate torsional deformation and shear stress due to an applied force in a door handle design. A locked door handle is composed of a solid circular shaft AB with a diameter fb = 105 mm and a flat plate BC with a force P = 76 N applied at point C as shown. Let c = 543 mm, d = 125 mm, and e = 145 mm. (Treat the handle as if it were a cantilever beam.)...
Learning Goal: To calculate torsional deformation and shear stress due to an applied force in a door handle design. A locked door handle is composed of a solid circular shaft AB with a diameter fb = 105 mm and a flat plate BC with a force P = 76 N applied at point C as shown. Let c = 543 mm, d = 125 mm, and e = 145 mm. (Treat the handle as if it were a cantilever beam.)...