Explain what thermopile is and how using a thermopile versus a thermocouple affects measurement sensitivity.
Explain what thermopile is and how using a thermopile versus a thermocouple affects measurement sensitivity.
Answer both questions
6. Explain the diagram below. eeform Chat Weselom Chart 7. Obtain the sensitivity of thermocouple that we used from the given graph Thermocouple Potential vs Temperature 70 Type E TypeJ 60 _ Type N Type R Types -TypeT 30 10 10 00-200-100 100 200 300 400 500 600 700 800800 1000 1100 1200 1300 1400 1500 1600 1700 1800 www.osis indutrisbdid-syrtens Temper aturer
6. Explain the diagram below. eeform Chat Weselom Chart 7. Obtain the sensitivity of...
Explain how eating plant protein versus meat protein affects the following: (25 pts.) Saturated fat Total fat Cholesterol Fiber Total kcalories
Using scientific principles, explain in detail how ambient temperature affects resistance and what are its consequences on power ratings of a carbon resistor in a circuit?
Using the Aggregate Demand/ Aggregate Supply Model, explain how lowering the reserve ratio affects the economy.
3. (a) What is the difference between the signal measurement methods in differential mode' vs 'single ended measurement"? (b). A 14 bit A to D converter is to be employed with an Iron-constantan thermocouple. What temperature resolution can be expected with a full scale voltage of 100 mV? Thermocouple shows 0.5 mV at 50°C and 3.052 mV at 100°C.
3. (a) What is the difference between the signal measurement methods in differential mode' vs 'single ended measurement'? (b). A 14 bit A to D converter is to be employed with an Iron-constantan thermocouple. What temperature resolution can be expected with a full scale voltage of 100 mV? Thermocouple shows 0.5 mV at 50°C and 3.052 mV at 100°C.
Using Arduino create a program that performs the temperature control of an oven. The thermocouple sensor it works 0 oC at 100 oC delivering a voltage of 0V through a transducer to 5V. It is necessary to average the voltage of 10 sensor samples to have better accuracy in the measurement. If the average temperature is higher than 50 degrees then the cold water recirculation pump is turned on for 30 seconds. Simulate the sensor with a voltage divider using...
a) Explain how, i) the interest sensitivity of private spending and ii) marginal propensity to consume, determine the slope of an iS curve. b) Suppose the Reserve Bank of Australia (RBA) is concemed about recession and wants to adopt an expansionary monetary policy. Explain, using the IS-LM diagram(s), how the effectiveness of monetary policy in increasing the output level may depend on the interest sensitivity of investment spending
a) Explain how, i) the interest sensitivity of private spending and ii)...
Identify a chemical exposure in water. Explain what this chemical exposure is, how it affects the health of individuals, and how it can be prevented. Be descriptive and give sufficient detail.
Identify a chemical exposure in air. Explain what this chemical exposure is, how it affects the health of individuals, and how it can be prevented. Please be descriptive and give sufficient detail.