using norsonic microphone with sensitivity of 50.9mv/pa determine the amount of voltage induced if the mic were to be imposed by sound source of 80dB.
using norsonic microphone with sensitivity of 50.9mv/pa determine the amount of voltage induced if the mic...
1) A quartz piezoelectric crystal having a thickness of 2 mm and a voltage sensitivity of 0.055 V · m/N is subjected to a pressure of 200 psi. Calculate the voltage output. 2) A Hall-effect transducer is used for the measurement of a magnetic field of 5000 G. A 2-mm slab of bismuth is used with a current of 3 A. Calculate the voltage output of the device. 3)In a Michelson interferometer, 100 fringes cross the field of view when...
Question 15 5 pts The amount of voltage induced in the coil is proportional to the rate of induced voltage change of current change of voltage applied voltage D Question 16 5 pts XL = 2TfL What is the above formula used to calculate? inductive resistance inductive reactance capacitive reactance capacitive resistance
said that one of the factors to determine the voltage(emf) that can be induced into the coil using just magnetism is by increasing the magnetic field strength so, how to increase the strength of the magnetic field?
82 PA PA (v) USING VOLTAGE DİVIR. 20 CALCULATE ANO 2.7K 3.3kg 10k 오 G.8K2 8.22 104요 82 PA PA (v) USING VOLTAGE DİVIR. 20 CALCULATE ANO 2.7K 3.3kg 10k 오 G.8K2 8.22 104요
Using superposition, determine the value of the output voltage due to the voltage source only (V01), and due to the current source only (V02).
a) Using nodal analysis determine the voltage across the 1 ohm resistor. b) using mesh analysis determine the current across the voltage source. nr )edder me nu current Nh) wsern esh analysis
(9) Determine the amount of power the 4 A current source delivers to the circuit below. (Solve using the mesh-current method only, but reflect on the complexity of using node-voltage (Source: Nilsson and Reidel, 9th edition.) 4Ω 120 V 20 Ω 80 V 702 1Ω 4 A
Q5 An experimental was performed to determine the input resistance of a computer sound system. A6 Volt signal source, a 4.7 k Ohm resistor, and the two input leads to the sound system were connected in series. When the voltage was measured across the input leads of the sound system, it was 3.8 Volts. What is the input resistance of the system?
Answer # 3,27 PROBLEMS 3.27 Use mesh analysis to determine the amount of power supplied by the voltage source in the circuit of Fig. P3.27. 8Ω 9 A 2Ω 4Ω +40 V Figure P3.27: Circuit for Problem 3.27. 28 Determine V in the circuit of Fig. P3.28 using mesh alysis 4Ω 4Ω
Problem8 The voltage source V-25V. Determine: 10Ω 15Ω 30Ω 20Ω 40Ω SPECIFY EXPLICITLY WHAT METHOD YOU ARE USING TO SOLVE THE PROBLEMM a. b. c. The source current Is The voltage across the 152 resistor The power dissipated by the 402 resistor