Q5 An experimental was performed to determine the input resistance of a computer sound system. A6...
A load impedance consists of 25 ohm resistance in series with 38 ohm inductive reactance. The load is connected across a 60 Hz, 240 V rms source. Use the voltage source as the reference (zero phase angle). a. Draw the circuit diagram. b. Calculate the value of inductance. c. Calculate the phasor value of current through the load impedance. d. Which leads, current or voltage? e. What is the phase angle between current and voltage? d. Calculate the phasor value...
Need help with conclusion questions please 1. The objectives of this lab are (1) to determine the actual (A) total resistance of three resistors connected in series and compare it with the experimental (E ) value of total resistance (2) to determine the actual (A) total resistance of three resistors connected in parallel and compare it with the experimental(E ) value of total resistance II. Apparatus(Equipment): Voltage source, ammeter that measures current , voltmeter that measures voltage. II. Procedure: Three...
A resistor was connected to a variable voltage source and the current was measured for various voltages.The following results were obtained: Trial Voltage (V) Current (mA) 1 1 3.3 2 1.96 7.1 3 3.03 10.9 4 3.98 13.7 where V is the voltage difference across the resistor and I is the current travelling through the resistor at the same time. Calculate the resistance for each trial and the average of the resistances. Determine the uncertainty in the average resistance. Report...
Part A A group of students performed the same "Ohm's Law" experiment that you did in class. They obtained the following results: Trial ΔV (volts) I (mA) 1 1.00 20.5 2 2.10 42.0 3 2.90 57.5 4 3.90 78.0 5 4.90 98.0 where ΔV is the voltage difference across the resistor and I is the current traveling through the resistor at the same time. (a) Analyze the data. (You will not submit this spreadsheet. However, the results will be needed...
Multiple Choices: 1pt _1. If the resistance of a copper wire is 1002 at 20°C, what is its resistance at 60°C? A. 11662 B. 12522 C. 13492 D. 14322 2. Three resistors of 2022, 60 2 and 100 are connected in parallel. The current through the 100 2 is 120mA. Determine the current through 2012 resistor, A. 1000mA B. 800mA 600mA D. 400mA 3. Three resistors of 6 ohm resistance are connected in delta. Determine the measured resistance of an...
Exercise 31.13 - Enhanced - with Feedback You have a resistor of resistance 1902, an inductor of inductance 0.450 H, a capacitor of capacitance 6.40 pF and a voltage source that has a voltage amplitude of 26.0 V and an angular frequency of 300 rad/s. The resistor, inductor, capacitor, and voltage source are connected to form an L-R-C series circuit. Part A What is the impedance of the circuit? Express your answer in ohms. VOI ΑΣΦ FR ? Z= 12...
I am working on my Physics lab report where it was all about Direct Current Measurement and Ohm’s Law. We had 5 different resistors and had to construct different circuits using a power supply, volt-ohm-milliammeter (VOM) and a digital multimeter to get measurements of resistance, voltage, and current. Nominal values of resistance and tolerance Resistor Nominal Resistance (Ohms) Tolerance (Ohms) R1 680 +/- 68 R2 1000 +/- 50 R3 1500 +/- 75 R4 4700 +/- 470 R5 10,000 +/- 500...
Pease answer questions 4 and 5! Thank you so much! 4. Connect the 2nd resistor in parallel with the 1st resistor and connect that combination to the battery. Measure the following: The current passing through the R1, I1 = ___0.0058____ A The current passing through the R2, I2 = ___0.0031____ A The current supplied by the battery, I = ___0.0092____ A Calculate I1 + I2 = ____________ A Is the following statement true? I = I1 +...
Use the exact values you enter to make later calculations. Part A A group of students performed the same "Ohm's Law" experiment that you did in class. They obtained the following results: Trial ΔV (volts) I (mA) 1 1.00 5.3 2 1.90 9.5 3 3.00 16.3 4 4.00 20.6 5 4.90 25.3 where ΔV is the voltage difference across the resistor and I is the current traveling through the resistor at the same time. (a) Analyze the data. (You will...