Question

The lab is the acid catalysed hydrolysis of ethyl acetate. Experimental Pipette 100.0 cm3 of 0.5...

The lab is the acid catalysed hydrolysis of ethyl acetate.

Experimental

  1. Pipette 100.0 cm3 of 0.5 M HCl into a conical flask (labeled A) and a further 20.0 cm3 into a second conical flask (labeled B).
  2. Prepare 25 cm3 of crushed-ice/water. Pipette 5.0 cm3 of ethyl acetate into flask A, shake well, start the stop watch and immediately withdraw 5.0 cm3 of the solution. Immediately, run this into the crushed-ice water mixture, and swirl to 'stop' the reaction, and as soon as possible titrate with the NaOH solution. Without ever stopping the watch, note the time to the nearest second at which the solution is run into the ice/water mixture. This is the first time, t1, of the series.
  3. About 10 min after the first withdrawal, pipette another 5.0 cm3 of the reaction mixture from the flask and titrate as before, again noting the exact time, t2, that the reaction is 'stopped'.
  4. Further titrations are made at times of about 20, 30, 40, 60, 80, 100 and 120 min.
  5. The reaction is accelerated to completion by heating to 70°C for ½ hr. During this time the flask must be stoppered to avoid changes in concentration due to evaporation. Cool to room temperature, pipette 5.0 cm3 and add to 25 cm3 of water and titrate as before.
  6. For a control, take flask B and add 1 cm3 of water, pipette 5.0 cm3 and titrate as before.

Calculation

The initial ethyl acetate concentration is proportional to (V - Vo), where V is the final titre volume for flask A and Vo is the titre volume for flask B. The concentration of ethyl acetate at time t is proportional to (V - Vt) where Vt is the titre volume of the sample at time t. Plot ln(V - Vt) against time. Hence determine the value of k1 (in s-1) and the half-life of the reaction.
Question

  1. If the temperature of the reaction increased by about 2°C during the course of the reaction, what effect would this have on the points plotted?
  2. Assume the activation energy, Ea, to be about 11 kJ mol-1, calculate the fractional variation in the rate constant that would result from this increase in temperature.
0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
The lab is the acid catalysed hydrolysis of ethyl acetate. Experimental Pipette 100.0 cm3 of 0.5...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • in FRIEDEL-CRAFTS ACYLATION AND COLUMN CHROMATOGRAPHY lab (2 pts) Amount of acetyl chloride used ____4______(drops) (each...

    in FRIEDEL-CRAFTS ACYLATION AND COLUMN CHROMATOGRAPHY lab (2 pts) Amount of acetyl chloride used ____4______(drops) (each drop is 0.01 mL) _____2______(equivalents) Based on the amount of ferrocene you began the Friedel-Crafts reaction with, determine the percent yield of acetylferrocene, diacetylferrocene, and the percent recovery of unreacted ferrocene (show work) react by 0.100 g of ferrocene at beginning got 0 g of ferrocene, 0.012g of diacetylferrocene , 0.017g of acetylferrocene REACTION PROCEDURE: To a 5 mL conical vial, add a spin...

  • lab math about micropipetting Pipette Calibration Check Use this link below to view short video that...

    lab math about micropipetting Pipette Calibration Check Use this link below to view short video that demonstrates pipette calibration check. https://www.youtube.com/watch?v=1zYxCsKgs80 Lab Math Review 1. Calculate the Mean delivered volume of the P200 pipette being checked using the values(L): 150, 151, 151, 150 and 152. So.8 2. Dilute a 100X (100 times concentrated) stock solution with D-H2O to make 5L of a 1X solution. What volume of stock and D-H20 are needed? 3. A solution contains 10g of solute dissolved...

  • Draw a pathway for the reaction of phenylboronic acid with 4-iodophenol to obtain 4-phenylphenol in the...

    Draw a pathway for the reaction of phenylboronic acid with 4-iodophenol to obtain 4-phenylphenol in the form of a catalytic cycle. EXPLAIN and STATE all complexes formed in EACH STEP by their electron counts (count how many e- are there, e.g. 18 e- or 16 e- etc.), formal oxidation states and all the reactions with mechanistic labels (i.e. oxidative addition, reductive elimination, etc.) (note the amount of base used). Be sure to EXPLAIN the catalytic cycle as to what happens...

  • volume= 15 mL CHEMICAL KINETICS: HYDROLYSIS OF ETHYL LACTATE PRE-LAB ASSIGNMENT: Determine the value of the...

    volume= 15 mL CHEMICAL KINETICS: HYDROLYSIS OF ETHYL LACTATE PRE-LAB ASSIGNMENT: Determine the value of the rate constant for the hydrolysis of ethyl lactate from the followin data. It was collected using exactly the same procedure as you will in the lab. Mass of ethyl lactate (grams): 0.5966 Concentration of stock HCl solution: 0.01002 M Standardization titration volumes (of NaOH): Run Vi (mL) V (mL) 1 1.68 17.40 2 17.40 33.10 3 33.10 48.84 Kinetics data: Vi (mL) V (mL)...

  • 3-5 pls Post-Laboratory Questions-EXP 3 Nitration of Aromatic Compounds Name: Due after completing the lab. 1....

    3-5 pls Post-Laboratory Questions-EXP 3 Nitration of Aromatic Compounds Name: Due after completing the lab. 1. Why is concentrated sulfuric acid employed in this reaction? What is the electrophile that is produced by the reaction of sulfuric acid and nitric acid? 2. Why is it important to maintain the reaction temperature low and the addition of nitric acid-sulfuric acid mixture carried out slowly? 3. Explain why concentrated H2SO, not concentrated HCl, was used in this experiment? 4. Which ring of...

  • numbers 1-3 Post-Laboratory Questions-EXP 3 Nitration of Aromatic Compounds Name: Due after completing the lab. 1....

    numbers 1-3 Post-Laboratory Questions-EXP 3 Nitration of Aromatic Compounds Name: Due after completing the lab. 1. Why is concentrated sulfuric acid emploved in thie on? What is the electrophile that is produced by the reaction of sulfuric acid and nitric acid? 2. Why is it important to maintain the reaction temperature low and the addition of nitric acid-sulfuric acid mixture carried out slowly? 3. Explain why concentrated H2SO4, not concentrated HC1, was used in this experiment? 4. Which ring of...

  • All of the solutions used today can be washed down the sink with water. Solid waste...

    All of the solutions used today can be washed down the sink with water. Solid waste should be thrown in the bin. Experimental This experiment is to be carried out individually NOTE: Failure to follow the correct procedures as explained in Skill 4 will result in wildly inaccurate results. The notes below do NOT give a full description of the techniques. 0 2 Standardisation of 0.1 M sodium hydroxide with the primary standard potassium hydrogenphthalate Part A (Al) In a...

  • For the nitration of methyl benzoate: a. Which product did you get? What evidence do you...

    For the nitration of methyl benzoate: a. Which product did you get? What evidence do you have for this? b. Was your product pure? What evidence do you have for this? Explain your evidence. c. Draw the mechanism for the product you got. For the bromination of acetanilide: a. Which product did you get? What evidence do you have for this? b. Was your product pure? What evidence do you have for this? Explain your evidence. c. Draw the mechanism...

  • I need to: DETERMINE THE CONCENTRATION OF HYDROGEN PEROXIDE IN THE SOLUTION how ?? THEORY Titrimetry,...

    I need to: DETERMINE THE CONCENTRATION OF HYDROGEN PEROXIDE IN THE SOLUTION how ?? THEORY Titrimetry, or titrimetric analysis, is an example of a so-called classical method of analysis. Titrimetry is a convenient method of getting very small amounts of chemicals in to a reaction because the method involves the use of dilute solutions of reactants. Hydrogen peroxide reacts with potassium iodide according to the reaction given below:                                         HB2BOB2B + 2HP+P + 2IP-P = IB2B + 2HB2BO                 (equation...

  • PROCEDURE CAUTION!!! Nitric acid and sulfuric acid are strong and corrosive acids. For that reason, avoid...

    PROCEDURE CAUTION!!! Nitric acid and sulfuric acid are strong and corrosive acids. For that reason, avoid inhaling its vapors or causing any contact with the skin or clothing. Wear your protective glasses at all times. Use the extractors to work with these acids. A. Nitration of methyl benzoate 1. Preparation of the reactants. In the extractor you will find a burette with concentrated sulfuric acid, a second burette with concentrated nitric acid, clearly identified. Familiarize yourself with the scales of...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT