A set of pumps need to be installed to transfer liquid from a storage tank into...
A set of pumps need to be installed to transfer liquid from a storage tank into a distillation column. Which engineering disciplines do you need to involve and what for?
My subject is Plant Engineering
Homework Answers
Add Answer to:
A set of pumps need to be installed to transfer liquid from a
storage tank into...
A liquid chemical is pumped from a storage tank open to the atmosphere, into a reactor...
A liquid chemical is pumped from a storage tank open to the atmosphere, into a reactor with pressure of 2.0 atm gauge above the liquid level. The liquid density is 1200 kg/m3 and viscosity is 1.45 cP. The required volumetric flow rate is 1.25 x 103 m/s. The pipeline is 100 m long in total, made of commercial steel pipe, 2 in. size and Schedule 40. The gate valve is wide open. 10 m Reactor Calculate: (a) The discharge velocity...
You must install a centrigual pump to transfer a volatile liquid from a removal tank .If...
You must install a centrigual pump to transfer a volatile liquid from a removal tank .If the liquid has a vapor pressure of 30 psia , the pressures in the tank is 30 psia , the level in the tank is 40 -ft above the pump inlet and the required pump NPSH is 20-ft ,what is the maximum length of the pump section side of the pump without the possibility of cavitation ? The line is 2-in schedule-70 commercial steel...
5. Liquid ethanol is pumped from a large storage tank through a 1-inch ID pipe at...
5. Liquid ethanol is pumped from a large storage tank through a 1-inch ID pipe at a rate of 3.00 gal/min. (a) At what rate in (i) ft lbels and (ii) hp is kinetic energy being transported by the ethanol in the pipe? (b) The electrical power input to the pump transporting the ethanol must be greater than the amount you calculated in Part (a). What would you guess becomes of the additional energy? (There are several possible answers.)
A liquid food product is being heated in a well-mixed tank. The sides of the tank are...
A liquid food product is being heated in a well-mixed tank. The sides of the tank are kept at 77°C. The tank is 1.69 meters in diameter and is filled with broth to a height of 0.5 meters. Under the current conditions, the convective heat transfer coefficient is 420 W/m2 K. Draw a diagram of the system and label all appropriate parts What kind of heat transfer is occurring from the tank to the broth? How do you know? How would your answer to...
I just need help understand where I get the 7 for the dx/dt 1. (5 points) Two large tanks, each holding 100 L of liquid, are interconnected by pipes, with the liquid flowing from Tank A into Tank B at...
I just need help understand
where I get the 7 for the dx/dt
1. (5 points) Two large tanks, each holding 100 L of liquid, are interconnected by pipes, with the liquid flowing from Tank A into Tank B at a rate of 3 L/min and from B into A at a rate of 1 L/min. The liquid inside each tank is kept well stirred. A brine solution with a concentration of 0.2 kg/L of salt flows into Tank A...
just need the truth tables sop and circuits CET 363 Digital Circuits Design Project Liquid storage...
just need the truth tables sop and circuits
CET 363 Digital Circuits Design Project Liquid storage tank control unit In this projact you will design the control unit for a liquid storage tank. The control unit monitors temperature and liquid levels. The unit will maintain the appropriate liquid level by controlling input and output valves. The control unit also controls a heater to maintain the correct temperature range. Finaly, an alarm is activated if the liquid is too hot or...
Your father installed a pump to draw water from a well to your house water tank....
Your father installed a pump to draw water from a well to your house water tank. The desired discharge is 70 Ls. He bought a pump (Pump 1) which delivers 2 kW of power to the water from a nearby hardware store. a) Evaluate whether the pump is adequate to deliver the desired flow rate to your house or not. b) Based on your evaluation, IF the pump is not sufficient to draw 70 Ls, propose a solution to solve...
question #2 please Reverse phase chromatography is the most common type of liquid chromatography which the...
question #2 please
Reverse phase chromatography is the most common type of liquid chromatography which the solid phase is made up of a packing material that is largely hydrophobic and the eluents are of varying polarities. In general, the more polar compounds elute first from the column followed by more hydrophobic compounds. PRELAB QUESTIONS 1. Draw structures for the following analytes for the simulation: a. acetophenone b. benzophenone c. butylparaben d. propiopheneone e. ethylparaben f. propylparaben g. ketoprofen h. 3-nitrophenol...
GOAL Solve a problem involving heat transfer and a phase change from solid to liquid. PROBLEM...
GOAL Solve a problem involving heat transfer and a phase change from solid to liquid. PROBLEM At a party, 6.00 kg of ice at -5.00°C is added to a cooler holding 30 liters of water at 20.0°C. What is the temperature of the water when it comes to equilibrium? STRATEGY In this problem, its best to make a table. With the addition of thermal energy Dice the ice will warm to 0°C, then melt at 0°C with the addition of...
an ICU nurse and are expecting a transfer from the emergency department. What type of information do you need in the rep...
an ICU nurse and are expecting a transfer from the emergency department. What type of information do you need in the report from the transferring nurse? How do you prepare the room for the patient transfer? What information do you provide to the patient upon his or her arrival?
A liquid chemical is pumped from a storage tank open to the atmosphere, into a reactor with pressure of 2.0 atm gauge above the liquid level. The liquid density is 1200 kg/m3 and viscosity is 1.45 cP. The required volumetric flow rate is 1.25 x 103 m/s. The pipeline is 100 m long in total, made of commercial steel pipe, 2 in. size and Schedule 40. The gate valve is wide open. 10 m Reactor Calculate: (a) The discharge velocity...
5. Liquid ethanol is pumped from a large storage tank through a 1-inch ID pipe at a rate of 3.00 gal/min. (a) At what rate in (i) ft lbels and (ii) hp is kinetic energy being transported by the ethanol in the pipe? (b) The electrical power input to the pump transporting the ethanol must be greater than the amount you calculated in Part (a). What would you guess becomes of the additional energy? (There are several possible answers.)
I just need help understand
where I get the 7 for the dx/dt
1. (5 points) Two large tanks, each holding 100 L of liquid, are interconnected by pipes, with the liquid flowing from Tank A into Tank B at a rate of 3 L/min and from B into A at a rate of 1 L/min. The liquid inside each tank is kept well stirred. A brine solution with a concentration of 0.2 kg/L of salt flows into Tank A...
just need the truth tables sop and circuits
CET 363 Digital Circuits Design Project Liquid storage tank control unit In this projact you will design the control unit for a liquid storage tank. The control unit monitors temperature and liquid levels. The unit will maintain the appropriate liquid level by controlling input and output valves. The control unit also controls a heater to maintain the correct temperature range. Finaly, an alarm is activated if the liquid is too hot or...
Your father installed a pump to draw water from a well to your house water tank. The desired discharge is 70 Ls. He bought a pump (Pump 1) which delivers 2 kW of power to the water from a nearby hardware store. a) Evaluate whether the pump is adequate to deliver the desired flow rate to your house or not. b) Based on your evaluation, IF the pump is not sufficient to draw 70 Ls, propose a solution to solve...
question #2 please
Reverse phase chromatography is the most common type of liquid chromatography which the solid phase is made up of a packing material that is largely hydrophobic and the eluents are of varying polarities. In general, the more polar compounds elute first from the column followed by more hydrophobic compounds. PRELAB QUESTIONS 1. Draw structures for the following analytes for the simulation: a. acetophenone b. benzophenone c. butylparaben d. propiopheneone e. ethylparaben f. propylparaben g. ketoprofen h. 3-nitrophenol...
GOAL Solve a problem involving heat transfer and a phase change from solid to liquid. PROBLEM At a party, 6.00 kg of ice at -5.00°C is added to a cooler holding 30 liters of water at 20.0°C. What is the temperature of the water when it comes to equilibrium? STRATEGY In this problem, its best to make a table. With the addition of thermal energy Dice the ice will warm to 0°C, then melt at 0°C with the addition of...
Most questions answered within 3 hours.
-
Calculate the specific heat of a certain unknown metal, if it
requires 195 joules of heat...
asked 7 minutes ago -
Identify the characteristics of a successful
project.
Describe the phases the project lifecycle.
Define the roles...
asked 16 minutes ago -
1. In Module 2 "headers" and "footers" are
described. Explain the difference between them and how...
asked 11 minutes ago -
Three polarizing filters are stacked with the polarizing axes of
the second and third at 58.5...
asked 20 minutes ago -
The capacitance in a series RCL circuit is C1 = 3.3 μF, and
the corresponding resonant...
asked 30 minutes ago -
A 357.7-gram sample of an unknown substance (MM = 92.41 g/mol)
is heated from -23.1 °C...
asked 29 minutes ago -
The project aims to design a network for a casino. The casino
has 10 floors including...
asked 34 minutes ago -
Combustion of an unknown compound containing only carbon and
hydrogen produces 54.9 g of CO₂ and...
asked 50 minutes ago -
A basketball player achieves a hang time, the total time of
flight, of 0.748 s when...
asked 50 minutes ago -
A processor of carrots cuts the green top off each carrot,
washes the carrots, and inserts...
asked 1 hour ago -
Please help me find the coefficient of kinetic and static
friction of two masses (500kg and...
asked 59 minutes ago -
Stanley Department Stores reported net income of $815,000 for
the year ended December 31, 2018.
Additional...
asked 1 hour ago