Please design 3 different and unique brackets consisting of TOP, FRONT, RIGHT or LEFT views with appropriate dimensions
I did search in google and get the design of the bracket and dimensions i design in solidworks software
So if it any wrong or change in design please be comment
I hope it will help you Thank you..
Please design 3 different and unique brackets consisting of TOP, FRONT, RIGHT or LEFT views with...
2. Draw multiviews below (here they are top, front and right side views) as front, top and left-side view and add mising lines. Use red pencil for missing lines. And please watch the video named missing lines) that I uploaded on Ims for help. the missing line EXAMPLE 1 Soun 986622ELA DUOLE
Sketch front, right side, left side, bottom and back
views.
sketch: Front, Right side, Left Side. Bottom & Back Views 8
sketch: Front, Right side, Left Side. Bottom & Back Views 8
sketch the top, front and right side views using third- angle
projection full scale
FRONT BOTTOM LEFT CORNER OF FRONT-VIEW 50 INCH SOLARES (10 IN. GRID ASSIGNMENT: SKETCH THE TOP, FRONT, AND RIGHT SIDE VIEWS USING THIRD-ANGLE PROJECTION. FULL SCALE. ALLOW 1 IN BETWEEN VIEWS STEP BRACKET A-5
sketch an isometric view given top front and right
views.
ㄚ Top, Front & the side views are given. Sketch an isometric view.
Please draw the top,front and right view for the following
isometric views.
Please don't forget to use engineering paper.
PLEASE DRAW THIS IN AUTOCAD
TOP FRONT AND RIGHT SIDE VIEWS
INCLUDE HIDDEN AND CENTER LINES
8. Below 1.00 1.50 0.75 2.50 2 x 0.50- 1.50
Isometric & Oblique 1. Given the front, top and right side views of the object, sketch the Isometric pictorial of the object. You may use isometric grid paper if desired. Keep the object in proportion. TOP Zoo FRONT RIGHT SIDE 2. Given the front and top views of the object, sketch the Oblique Cavalier pictorial of the object on Engineering paper at 30 degrees. Keep the object in proportion. - - ТОР FRONT
Given: The front and top views of an object.
Required: Draw the right side view and complete the bottom half
as instructed.
For part 2: Draw the right side view of surface
14,17,19,20,26.
ORTHOGRAPHIC READING GIVEN: The front and top views of an object. 10 REQUIRED: Draw the right side view and complete the bottom half as instructed. 13 14 15 16 17 18. 26 20 22 Draw the right side view of surface 14,17,19,20,26. 14 26
Exercise 4.9, page 172. Sketch front, top, and right-side
views for # 1 on grid paper or directly in CAD. Scale drawing to
fit paper. Shaw all dimensions. Add a bilateral angular tolerance
of +/-1 0.5° to the 30° angle. Is the right-side view really
needed?
LOCATER 2.12 l.O0 .06 .56 .12 30° 1.56 2.26 2.62 4.76 View here
2. Draw the orthographic projections - front, top and right side views for the given figure below. (20 points)