hi
Solve for the over-all Power Gain, Output Power, Quiescent Power, and Efficiency Vee 12V Qa 0, 0....
Apply the concept of Multistage O0000 O0000 The amplifier in Figure 5-36 is a low-power andio amplifier. The transfomer is step-down impedance-matching transformer designed to give a reflected reaistance in the primary of 1000 2 when the load is 8 2 (such as the speaker).. The dc resistance of the primary winding is 66 2 and B= 150 (a) Compute Va and the Ig for the transistor (b) Compote A A, and power delivered to the load when the input...
a) What is "power-conversion efficiency' of an output stage? Comparo the class-A and class-B amplifier output stages with rospect to their power-conversion officiencies. b) Assume that an emitter follower 9, is used as a class-A output stago, with the constant current supplied by another transistor 2. (as in Figure Q.4.a). Let Vcc=16V, 1 =100mA, and R=10002. If the output voltage is an 4-V-peak sinusoid, find the power conversion efficiency. VC Figure Q.4.a c) Explain the crossover distortion in a class-B...
NAME IIl. (34 pts).) The circuit below is a power amplifier. It should provide a power output of 12 Watts to an 8 Ohm load. The input resistance of the power amp (as seen by the signal source Vs) should be 20k Ohms. The maximum value of the signal source Vs is 0.5v rms Determine (a) The minimum values of the power supply voltages needed (+Vcc and-Vcc), (b) The values of resistors R1 and R2, (c) The minimum slew rate...
A transformer-coupled FE power amplifier must deliver an output of 0.5 Watt to an class ? istor has ?-100 and VBE 0.7 V. Assume zero resistance in the transformer. What ansistor power rating is needed? o Vcc Ce R2 Vin
u must show an expression (equation) before inserting in the numbers" β-40. The input signal results in a base 1. For the class A amplifier circuit of fig. Pl, current having a peak value of 5 mA. Determine: (a) The input power (P(d) and output power (Pofac). (b) The power loss (Ploss) and the efficiency (7) of this amplifier. 15 Vcc (18 V) Re-16 Ω 1.2 k2 Ci 100 pF Fig. PI u must show an expression (equation) before inserting...
1. Figure 1 shows a CE power amplifier in which the collector resistor serves also as the load resistor. Assume Bpc Bac 100 a. Determine the dc Q-point (lco and VCEQ). b. Determine the voltage gain and the power gain c. The power dissipated in the transistor with no load. d. The total power from the power supply with no load e. The signal power in the load with a 500 mV input. f. What changes would be necessary to...
If a l V rms signal source with an internal resistance of 50 Ω is connected to the amplifier in Figure what is the actual rms signal applied to the amplifier input? Assume Bac 200 +15 V RI 1.0 kΩ 01 Di C3 02 75 Ω 1.0 kΩ Class C Power Amplifiers A certain class C amplifier transistor is on for 10 percent of the input cycle. If Veetsa) 0.18 V and Ie(sa)25 mA, what is the average power dissipation...
Consider a class-A power amplifier using output transformer as in the beside figure, where the transformer ration N=1.5. β=100, VBE =0,6V. Determine: a/ Maximum power consumed by the load RL . b/ Average power supplied by the DC source. c/ Efficiency of the circuit. d/ Average power dissipation of BJT
8.4 a) b) Please solve Test Your Understanding TYU 8.4 For the common-emitter output stage shown in Figure 8.16(a), let Vcc = 12 V and RL = 1 k12. Assume the transistor Q-point is in the center of the load line. (a) Determine the quiescent power dissipated in the transistor. (b) Assume the sinusoidal output voltage is limited to a 9V peak-to-peak value. Determine (i) the average signal power delivered to the load, (ii) the power conversion efficiency, and (iii)...
The switch in an effective LR series dc-circuit (consisting of an emf and a coil with inductance L = 0.5 H and unknown internal resistance) is closed at t = 0 sec. At t = r, the current is 9.5 A and is increasing at a rate of 1.1 A/s. What must the internal resistance of the coil be? A step-up transformer is designed to have an output voltage of 1800 V (rms) when the primary is connect across a...