HW Bearings 4 Required information A 02-series single-row deep-groove ball bearing is to be selec...
HW Bearlngs Required information A 02-series single-row deeo-groove oall bearing is to oe selected trom lable 11-2 tor t conditions specited in the tableme Talble 11-1 is applicable if needed The value of raa oad Fr 8 kN, axial load Fa kN, design life LD10ringrotation factor V12 and eliability R 0.9a NOTE: This is a mult-part question. Once an answer is submitted, you will be unable to return to this part. the application 25 poimts Assuming that the values taken...
mechanical Desgin 2 11 - 20: A single-row deep-groove ball bearing with a 65-mm bore (see Tables 11-1 for specifications) is loaded with a 3-KN axial load and a 7-KN radial load. The outer ring rotates at 500 rev/min. (a) Determine the equivalent radial load that will be experienced by this particular bearing. (b) Determine whether this bearing should be expected to carry this load with a 95 percent reliability for 10 kh.
tables that would help u Q-4 An 02-series single-row deep-groove ball bearing with a 30-mm bore (see Tables 11-1 and 11-2 for specifications) is loaded with a 2-kN axial load and a 5-KN radial load. The inner ring rotates at 400 rev/min. (a) Determine the equivalent radial load that will be experienced by this particular bearing. [15 pts.] (6) Determine the predicted life (in revolutions) that this bearing could be expected to give in this application with a 99 percent...
Table 11-2 Dimensions and Load Ratings for Single-Row 02-Series Deep-Groove and Angular-Contact Ball Bearings Load Ratings, kN Fillet Shoulder Width, Radius, Deep Groove Angular Contact Bore, OD, Diameter, mm ds C10 с. Сто Co mm mm mm mm 10 30 9 0.6 12.5 27 5.07 2.24 4.94 2.12 12 32 10 0.6 28 6.89 3.10 7.02 3.05 14.5 15 35 11 0.6 17.5 31 7.80 3.55 8.06 3.65 17 40 12 0.6 19.5 34 9.56 4.50 9.95 4.75 20 47...
A Bearing A is a deep groove type and bearing B is an angular contact sölid shaft is mounted on two Single-Row 02-Seri es Ball bearings The radial loads are Fr2472N, FR 3422N, axial load is Pa and the minimum static rating is 11000N. The design characteristics are speed of 500rpm, d application factor is 1.25,xo 0.02,-4.459, b- 1.483,a reliability of each bearing is to be at least 95.0%. The inner rings sign life of 10000hr, manufacturer rated life 10....