An lce cube at a temperature of -20 oC is put in a plastic bowl and...
PHYS 205 Winter 2019 Lab 1 Homework NAME 4. Suppose we heat sample A, which is 150 g of ice at-10 C, and sample B, which is 150 gofice at 0 °C, in the same microwave oven until both samples of water are at 30 °C. Will the time taken to heat sample A be (a) longer than, (b) shorter than, or (c) equal to the time to heat sample B? Explain your reasoning. 5. An ice cube at a...
Some potentially useful information: cal c(water) 1.0 Ltusion (water)- 80 cal & k cal c(ice) 0.49 Lvap (water)- 540 cal gK 1. Last week we took a look at this problem and only required a qualitatively correct response. Most of you did a good job of breaking the overall process into three distinct portions. This week we built on some of those ideas and are in a better position to be more quantitative. As you revisit this problem, pay attention...
A) What is the final temperature of the system? Ignore any heat
exchange with the bowl or the surroundings.
B)What is the amount of ice (if any) remaining?
A large punch bowl holds 3.80 kg of lemonade (which is essentially water) at 25.0 °C. A 5.10x10-2. kg ice cube at -11.0 °C is placed in the lemonade.
A 0.25g ice cube is put into a thermos with 20.0g of
10.0°C water.
Will the ice cube increase or decrease in temp?
Will the water increase or decrease in temp?
will the two changes be equal? why?
what will the final temperature be?
I have this as a lab hmwk. I'm not sure
how to go about answering this because it feels like I'm missing
information.
Should I be using The specific heat of water? How would I find...
A(n) 70-g ice cube at 0°C is placed in 780 g of water at 20°C. What is the final temperature of the mixture? °C
Piece #3 (1 pt): I put an ice cube in my soda. If the ice cube gains 1000 J of heat, how much heat does the soda lose? Piece #4 (1 pt): How much energy would be required to raise the temperature of 1.00 kg of water from 20°C to 45°C? Piece #5 (1 pt): How much electrical energy would I need to raise the temperature of 1.00 kg of water from 20°C to 45°C if my heater was only...
(15 points) An ice cube of mass 0.0340 kg and temperature -10.00 °C is placed in the steam room at a gym. The steam room, which is quite large, is filled with 2.000 kg of steam at a temperature of 110.0 °C (a) (5 points) How much ice is present, and at what temperature, when the ice and steam reach thermal equilibrium? Your answer should be two numbers (b) (5 points) How much water is present, and at what temperature,...
HoMEWORK FOR INTRODUCTION TO HEAT AND TEMPERATURE 1. Approximately what is human body temperature on the Celsius temperature scale? Which is better at transferring heat, water or air? How does this fact explain the length of time it takes the temperature probe to reach thermal equilibrium with the air or water it is in? 2. 3. What effect does the evaporation of water have on the object from which it is evaporating? When has your body experienced this effect? 4....
Problems 1 through 5 below refer to the following graph. A 200 gram ice sample is placed in a closed (and otherwise evacuated) beaker on top of a bunsen burner. The initial temperature of the ice is -20 degrees Celcius. It is heated until all of the ice melts and turns into water, the water is heated until it boils, and it continues to be heated until all of the water turns into steam. The temperature of the water (in...
(a) How much heat transfer (in kJ) is necessary to raise the temperature of a 0.210 kg piece of ice from -22.0°C to 132°C, including the energy needed for phase changes? (Assume the substance remains at a constant volume throughout each stage of the heating process.) (b) How much time (in s) is required for each stage, assuming a constant 19.0 kJ/s rate of heat transfer? (Enter your answers as a comma-separated list. Enter your times in order from the...