The process of standardizing an internet protocol is performed by IESG (Internet Engineering Steering Group) which is a team working under IETF (Internet Engineering Task Force).
The basic steps to standardize any internet protocol are given below :
1. The protocol is submitted to IESG for consideration under the standardization process. At this stage it is refrred as proposed standard.
2. It undergoes the initial procedures and is presented as a standard protocol.
3. A series of reviews is done by the reviewing team and any change required is done before final standardization.
4. The protocol must operated successfully before as the team also studies the documentation regarding successful run. At this state it is refrred as draft standard.
5. After the above regress procedures the protocol is finally termed as standard internet protocol under TCP/IP suite. At this state it is referred as Final standard.
Need for standardization process :
1. Protocol Standardization ensures that the protocol is technically sound and in compliance with the Internet standards.
2. As internet services are used by wide variety of users one must ensures that any protocol that gets standardized meets the requirement of each and every user effectively.
3. Standardization process make sure that each and every protocol must provide a quality service to every user.
4. Any protocol going through standardization process must ensure that it is useful to the core architecture of the internet.
5. Another reason for standardization is uniformity of each and
every protocol accoding to a basic set of rules.
What is the process for standardizing an Internet protocol? Why is protocol standardization necessary?
Why is standardization of NaOH necessary? Select one: a. to ensure that hydrolysis did not occur prematurely b. It reacts with acids readily. c. NaOH is hygroscopic and is hard to weigh accurately. od to ensure that the mass added is consistent with the standard kilogram
You are describing the differences between IPv4 (Internet Protocol version 4) and IPv6 (Internet Protocol version 6) while addressing to a group of high school students attending a technology workshop. Of the following, which are true statements about IPv4 and IPv6 addressing? (Choose two.) A. The IPv4 address size is 32 bits, and it uses numeral values to indicate addresses. B. The IPv4 address size is 32 bits, and it uses hexadecimal values to indicate addresses. C. The IPv6 address...
1))When configuring the IP in the Internet Protocol Version 4 (TCP/IPv4) Properties on a replica why add the main domain controller IP address in the Preferred DNS server? 2)) What is the reason to get the following error when selecting location for system state recover : "The backup contains Active directory domain service which can be recovered only when the computer is started in directory services restore mode. Retry the system state recovery operation from DSRM."
Describe how to use applications and communication protocols in the Transmission Control Protocol/ Internet Protocol (TCP/ IP) suite to design IP addressing and subnetting solutions for variable length subnet masks in your small home network.
What layer of the Internet protocol does a non-routing switch operate at? What values does it use to determine output port? If it does not hold this value in its table, what is its default action?
Use the Internet to research and explore vulnerabilities that are related to TCP/IP (transmission control protocol/Internet protocol). In a 3–5-paragraph posting, provide the following information: Current vulnerabilities related to TCP/IP Countermeasures that address the vulnerabilities Recommended products for addressing TCP/IP vulnerabilities If you have experience with TCP/IP, include your own experience and recommendations in this posting.
name 5 network protocol with their applications, find their RFC with searching on internet ( if there are multiple RFC for one protocol, write the oldest one).
How should one go about standardizing service nomenclature, such as the process service names and outcomes in order to achieve a level of ease with implementing enterprise-wide software? Why must people be sold on the software and readiness to change before moving ahead with a large-scale implementation such as ERP?
- If you were to design a new application layer protocol to stream videos over the Internet, what transport layer protocol would you use, and why? What are the features of that protocol that make it suitable for your purpose? - From application layer to physical layer and back again, explain the process that a single packet message goes through to get encapsulated? What information is added at each layer. Clarify your assumptions. Is this an IPv4 or v6 network,...
IPsec is an extension of the Internet Protocol (IP) and is designed to secure the network communication through cryptography. Hence, IPSec can only be implemented at the Network Layer. True or False?