Homework Answers
Add Answer to:
Autotransformers (30 Points) Given: 50kVA, 2400V:240V Transformer. If the transformer above is reconnected as an autotransformer...
Q-1 A 60Hz, 480V/240V,960V A transformer is supplying a 960W passive load at 240V. The resistances...
Q-1 A 60Hz, 480V/240V,960V A transformer is supplying a 960W passive load at 240V. The resistances of the primary side and secondary side of the transformer are 1.092 and 0.252 respectively. If the no load losses of the transfomer is given by P-Vã 4800 W where Vn is the input voltage of the transformer in Volt. Answer the following: a) Calculate transformer efficiency b) Do you allow this transformer to be connected to 240V 50Hz distribution system? Explain. c What...
A single phase 60 Hz two-winding power transformer is rated at 2400V/240V and 100 kVA with...
A single phase 60 Hz two-winding power transformer is rated at 2400V/240V and 100 kVA with Zeq = 0.5 + j0.8 Ohm. If an autotransformer is built from this conventional transformer to supply a load at 2640V with supply voltage 2400V. Draw the autotransformer and calculate Zeq, the voltage, current and apparent power rating of the auto transformer. Also calculate the apparent power rating advantage of autotransformer over conventional transformer.
Problem 5: A single phase 60 Hz two-winding power transformer is rated at 2400V/480V and 150...
Problem 5: A single phase 60 Hz two-winding power transformer is rated at 2400V/480V and 150 kVA. If an autotransformer is built from this conventional transformer to supply a load at 2880V with supply voltage 2400V. Draw the autotransformer and calculate the voltage, current and apparent power rating of the auto transformer. Also calculate the apparent power rating advantage of autotransformer over conventional transformer.
d) Consider an ideal, single-phase 2400V-240V transformer. The primary is connected to a 2200V source and...
d) Consider an ideal, single-phase 2400V-240V transformer. The
primary is connected to a 2200V source and the secondary is
connected to an impedance of 2Ω ∠36.9o , find all the values in
Table 1.
Table 1
No
Parameters
1
The secondary output current and voltage.
2
The primary input current
3
The load impedance as seen from the primary side.
4
The input and output apparent power
5
The output power factor
e) A 30MVA 33/11 kV star-delta three phase...
Given: 100kVA single phase transformer, Z=1.5% Primary: 480V 2 wire Secondary: 120/240V 3 wire Install the...
Given: 100kVA single phase transformer, Z=1.5% Primary: 480V 2 wire Secondary: 120/240V 3 wire Install the above transformer to serve a branch circuit panelboard. The panelboard will be located 10' from the transformer. The primary side raceway is PVC and the secondary raceway is EMT. All calculations will conform to applicable NEC regulations. The primary side, overcurrent protection device, will be chosen based on the next available standard size of the full load amps of the transformer. The secondary side,...
Questions [L] A transformer works with: AC current, BC current, CC current, DC current (2) The...
Questions [L] A transformer works with: AC current, BC current, CC current, DC current (2) The input side of a transformer is known as the: initial, startup, primary, input. [] The iron core transfers: current, voltage, induction, magnetism. [4] The changing magnetic flux through the secondary coil creates: 2 electricity, magnetic poles, transformers, the flux capacitor. [5] The current flowing through the primary coil creates: magnetism, electric poles, transformers, the flux inductor, [6] The primary coil has the less turns....
(BEKG 2433/BEKP 2323) c) You are required to inspect a new purchased transformer rating as shown...
(BEKG 2433/BEKP 2323) c) You are required to inspect a new purchased transformer rating as shown in Table Q3(c). The HV winding (primary) of the transformer is connected to the alternating power supply of 2200V and the LV winding (secondary) is connected to a load of 22 236.9", find all the values in Table 1. Table Q3(c): A typical transformer nameplate ABB transformer Volt-amperage: 50 KVA Single-phase HV winding: 2400 V LV winding: 240 V Frequency: 60 M2 Percent impedance:...
1. A step down transformer with a turns ratio of 6 to 1 has 120V applied...
1. A step down transformer with a turns ratio of 6 to 1 has 120V applied to its primary coil. A 25Ω load resistor is connected to the secondary coil. Calculate the following (3+2+2 -7 Points) Secondary coil voltage Secondary coil current Primary coil current a. b. c. 2. A step up transformer has a primary coil current of 1SA and an applied voltage of 220V. The secondary coil current is 5A. Calculate the following (3+3+2+2-10 Points) Secondary coil voltage...
Problem 3 A 50-Hz transformer is operated from a 60 Hz supply. Assume that the load...
Problem 3 A 50-Hz transformer is operated from a 60 Hz supply. Assume that the load does not change. Discuss the corresponding effects on its flux, reactive power requirements, losses, and efficiency. а- [5 Points] A 50-kVA, 2400/240 V, 60-Hz, single-phase distribution transformer has the following equivalent circuit parameters referred to the high-voltage side Xea 3.0 Req= 0.5 Xm 4,500 S2 Use the equivalent Cantilever model circuit shown in Figure (1). Assume that the load on the secondary of the...
2. The local transformer shown below provides the last voltage stepdown in a power distribution system....
2. The local transformer shown below provides the last voltage stepdown in a power distribution system. A common sight on utility poles in residential areas, it is a single-phase transformer that typically has a 13.8-LV rms line to neutral on its primary coil, and a center tap secondary coil provides both 120 Vrms and 240 Vrms to service several residences. A typical example of this transformer is shown below. Find the tums ratio necessary to produce the 240-V mms secondary...
Q-1 A 60Hz, 480V/240V,960V A transformer is supplying a 960W passive load at 240V. The resistances of the primary side and secondary side of the transformer are 1.092 and 0.252 respectively. If the no load losses of the transfomer is given by P-Vã 4800 W where Vn is the input voltage of the transformer in Volt. Answer the following: a) Calculate transformer efficiency b) Do you allow this transformer to be connected to 240V 50Hz distribution system? Explain. c What...
d) Consider an ideal, single-phase 2400V-240V transformer. The
primary is connected to a 2200V source and the secondary is
connected to an impedance of 2Ω ∠36.9o , find all the values in
Table 1.
Table 1
No
Parameters
1
The secondary output current and voltage.
2
The primary input current
3
The load impedance as seen from the primary side.
4
The input and output apparent power
5
The output power factor
e) A 30MVA 33/11 kV star-delta three phase...
Questions [L] A transformer works with: AC current, BC current, CC current, DC current (2) The input side of a transformer is known as the: initial, startup, primary, input. [] The iron core transfers: current, voltage, induction, magnetism. [4] The changing magnetic flux through the secondary coil creates: 2 electricity, magnetic poles, transformers, the flux capacitor. [5] The current flowing through the primary coil creates: magnetism, electric poles, transformers, the flux inductor, [6] The primary coil has the less turns....
(BEKG 2433/BEKP 2323) c) You are required to inspect a new purchased transformer rating as shown in Table Q3(c). The HV winding (primary) of the transformer is connected to the alternating power supply of 2200V and the LV winding (secondary) is connected to a load of 22 236.9", find all the values in Table 1. Table Q3(c): A typical transformer nameplate ABB transformer Volt-amperage: 50 KVA Single-phase HV winding: 2400 V LV winding: 240 V Frequency: 60 M2 Percent impedance:...
1. A step down transformer with a turns ratio of 6 to 1 has 120V applied to its primary coil. A 25Ω load resistor is connected to the secondary coil. Calculate the following (3+2+2 -7 Points) Secondary coil voltage Secondary coil current Primary coil current a. b. c. 2. A step up transformer has a primary coil current of 1SA and an applied voltage of 220V. The secondary coil current is 5A. Calculate the following (3+3+2+2-10 Points) Secondary coil voltage...
Problem 3 A 50-Hz transformer is operated from a 60 Hz supply. Assume that the load does not change. Discuss the corresponding effects on its flux, reactive power requirements, losses, and efficiency. а- [5 Points] A 50-kVA, 2400/240 V, 60-Hz, single-phase distribution transformer has the following equivalent circuit parameters referred to the high-voltage side Xea 3.0 Req= 0.5 Xm 4,500 S2 Use the equivalent Cantilever model circuit shown in Figure (1). Assume that the load on the secondary of the...
2. The local transformer shown below provides the last voltage stepdown in a power distribution system. A common sight on utility poles in residential areas, it is a single-phase transformer that typically has a 13.8-LV rms line to neutral on its primary coil, and a center tap secondary coil provides both 120 Vrms and 240 Vrms to service several residences. A typical example of this transformer is shown below. Find the tums ratio necessary to produce the 240-V mms secondary...
Most questions answered within 3 hours.
-
The tires of a car make 61 revolutions as the car reduces its
speed uniformly from...
asked 2 minutes ago -
Peabody, Inc., sells fireworks. The company’s marketing director
developed the following cost of goods sold budget...
asked 6 minutes ago -
A signal transduction pathway includes the steps listed
below.
1. An inactive signal transduction molecule is...
asked 5 minutes ago -
1. The correlation coefficient determined for two variables has
a value of 0.89. Describe, in words,...
asked 11 minutes ago -
The following data relate to direct materials costs for
November:
Actual costs
4,700 pounds at $5.35...
asked 9 minutes ago -
Kyle, a 95.0 kg football player, leaps straight up into the air
(with no horizontal velocity)...
asked 33 minutes ago -
Which of the following is a measure of profitability?
A.
Quick (acid-test) ratio
B.
Net sales...
asked 36 minutes ago -
Find the total pressure exerted by 2 grams of ethane and 3 grams
of CO2 contained...
asked 37 minutes ago -
A fireman standing on a 5.2 m high ladder operates a water hose
with a round...
asked 33 minutes ago -
A cream formulation is studied for accelerated stability study.
Creaming was observed when formulation was tested...
asked 36 minutes ago -
A 1,150 lumen light bulb is placed 37 cm in front of a mirrored
wall, whose...
asked 47 minutes ago -
Given that z is a standard normal random variable, compute the
following probabilities (to 4 decimals)....
asked 53 minutes ago