A uniform cylinder of mass m = 33 kg and radius 20 cm sits at rest...
A uniform cylinder of mass m = 33 kg and radius 20 cm sits at rest on a horizontal surface. It is held by a rope at point B which is connected to the vertical surface as shown. The static coefficient of friction at the contact point is 0.45.
If the force F is too large the cylinder will start to slip at the contact point. What is the maximum magnitude of force F in N before the cylinder slips?
Your answer should have 2 significant figures. Do not put units in your answer, only the calculated number.
Homework Answers
Add Answer to:
A uniform cylinder of mass m = 33 kg and radius 20 cm sits at
rest...
Q7 (15 points): A solid cylinder of mass 5 kg and radius R 0.15 m rolls...
Q7 (15 points): A solid cylinder of mass 5 kg and radius R 0.15 m rolls without slipping on a horizontal surface and is accelerated to the right by a constant force F of magnitude 6 N that is applied at the cylinder by a massless rope as shown in the below figure. Find a) the magnitude of the acceleration of the center of mass of the cylinder, b) the magnitude of the angular acceleration of the cylinder about the...
1977M2. A uniform cylinder of mass M, and radius R is initially at rest on a...
1977M2. A uniform cylinder of mass M, and radius R is initially at rest on a rough horizontal surface. The moment of inertia of a cylinder about its axis is ½MR. A string, which is wrapped around the cylinder, is pulled upwards with a force T whose magnitude is 0.0Mg and whose direction is maintained vertically upward at all times. In consequence, the cylinder both accelerates horizontally and slips. The coefficient of kinetic friction is 0.5 On the diagram below,...
A 20 kg box sits on a flat table. You pull horizontally (relative to the table...
A 20 kg box sits on a flat table. You pull horizontally (relative to the table surface) on a rope attached to the box. It just begins to slip when you pull 20 N. What is the coefficient of static friction (us) between the box and the table?
A 5.80-kg box sits at rest at the bottom of a ramp that is 8.20 m...
A 5.80-kg box sits at rest at the bottom of a ramp that is 8.20 m long and that is inclined at 40.0 ∘ above the horizontal. The coefficient of kinetic friction is μk = 0.40, and the coefficient of static friction is μs = 0.43. What constant force F , applied parallel to the surface of the ramp, is required to push the box to the top of the ramp in a time of 4.00 s ? Express your...
The spool with mass m-70 kg sits in a comer. A cord of negligible mass wraps...
The spool with mass m-70 kg sits in a comer. A cord of negligible mass wraps around the spool's inner cylinder. The spool's centroid corresponds with its mass center, G. The spool's outer radius is 500 mm. The radius of the inner cylinder is 260 mm. The coefficient of friction at contact points is a,-0.50. Determine the largest magnitude of the vertical force Fin newtons that one can pull on the cord before rotation of the spool occurs.
A solid uniform cylinder of mass M and radius R is at rest in the center...
A solid uniform cylinder of mass M and radius R is at rest in
the center on a flat slab of mass m and thickness d, which in turn
rests on a horizontal, frictionless table, as shown in the figure at
right below. A horizontal force of magnitude F is applied to the
slab, acting through the center of the slab, causing it to
accelerate to the right. The cylinder rolls without slipping on the
slab. (The direction of F...
A block of mass m1 sits on a block of mass m2. Block m2 rests on...
A block of mass m1 sits on a block of mass m2. Block m2 rests on a frictionless surface. The coefficient of static friction between block m1and m2 is µ. What is the maximum force F that can be applied to block m2 if block m1 is not to slip across the surface of m2? Express in terms of m1, m2, g, and µ.
Blocks B has a mass of 20 kg and block C has a mass of 15 kg. The coefficient of static friction at the contacting surfaces is 0.2. Block A is suspended by a rope that passes over a fixed cylinder and is attached to block B. The coefficient of static fric
Blocks B has a mass of 20 kg and block C has a massof 15 kg. The coefficient of static friction at thecontacting surfaces is 0.2. Block A is suspended by arope that passes over a fixed cylinder and is attachedto block B. The coefficient of static friction betweenthe rope and the cylinder is 0.25. What is the largestmass block A can have without causing block B to slipthe left?
1) A rope of negligible mass passes over a uniform cylindrical pulley of 1.50 kg mass...
1) A rope of negligible mass passes over a uniform cylindrical pulley of 1.50 kg mass and 0.090 m radius. The bearings of the pulley have negligible friction, and the rope does not slip on the pulley. On one end of the rope hangs a 3.00 kg bunch of bananas, and on the other end hangs a 4.50 kg monkey. Calculate the downward acceleration of the monkey and the tension in both ends of the rope. 2) A 200 g...
Consider a bicycle wheel of mass M and radius R that sits on a flat, level...
Consider a bicycle wheel of mass M and radius R that sits on a flat, level surface, such that the surface is tangent to the wheel. One end of a spring (spring constant, k) is attached to bicycle wheel’s hub, and the other end is fixed to a vertical wall. The spring is horizontal. There is sufficient friction to prevent the wheel from sliding at the point of contact with the surface. When the center of the wheel is directly...
Q7 (15 points): A solid cylinder of mass 5 kg and radius R 0.15 m rolls without slipping on a horizontal surface and is accelerated to the right by a constant force F of magnitude 6 N that is applied at the cylinder by a massless rope as shown in the below figure. Find a) the magnitude of the acceleration of the center of mass of the cylinder, b) the magnitude of the angular acceleration of the cylinder about the...
1977M2. A uniform cylinder of mass M, and radius R is initially at rest on a rough horizontal surface. The moment of inertia of a cylinder about its axis is ½MR. A string, which is wrapped around the cylinder, is pulled upwards with a force T whose magnitude is 0.0Mg and whose direction is maintained vertically upward at all times. In consequence, the cylinder both accelerates horizontally and slips. The coefficient of kinetic friction is 0.5 On the diagram below,...
The spool with mass m-70 kg sits in a comer. A cord of negligible mass wraps around the spool's inner cylinder. The spool's centroid corresponds with its mass center, G. The spool's outer radius is 500 mm. The radius of the inner cylinder is 260 mm. The coefficient of friction at contact points is a,-0.50. Determine the largest magnitude of the vertical force Fin newtons that one can pull on the cord before rotation of the spool occurs.
A solid uniform cylinder of mass M and radius R is at rest in
the center on a flat slab of mass m and thickness d, which in turn
rests on a horizontal, frictionless table, as shown in the figure at
right below. A horizontal force of magnitude F is applied to the
slab, acting through the center of the slab, causing it to
accelerate to the right. The cylinder rolls without slipping on the
slab. (The direction of F...
Most questions answered within 3 hours.
-
Provide two or three examples of support he uses to reinforce
his arguments?
The Alienation of...
asked 2 minutes ago -
In a titration experiment, 11.5 mL of 0.400 M H2SO4 neutralized
48.0 mL of NaOH. What...
asked 2 minutes ago -
A shot-putter throws the shot with a horizontal velocity of 10
m/s and a
vertical velocity...
asked 18 minutes ago -
Mildred sells industrial-sized refrigeration units. Her
prospective buyer's face looks tense, and his forehead is wrinkled....
asked 19 minutes ago -
Clark Heter is an industrial engineer at Lyons Products. He
would like to determine whether there...
asked 1 hour ago -
3. Use a text editor to create a comma-delimited file of user
IDs and passwords. Revise...
asked 1 hour ago -
Jensen and Associates has a projected balance
sheet that includes the following accounts. What is the...
asked 34 minutes ago -
implement a doubly-linked list in C. Each node in the linked list should contain a string,...
asked 57 minutes ago -
What are some best practices and things to avoid when developing
a PowerPoint presentation or file
asked 1 hour ago -
Consider the ways that the government can get involved in
economic issues. What role do you...
asked 35 minutes ago -
Sodium carbonate is added to the tea mixture, in part, to form
the sodium salt of...
asked 58 minutes ago -
he plant started to purify its wastewater before discharging it
into the lake. How long will...
asked 1 hour ago