Design a Colpitts Oscillator using Op Amps with a frequency fo > 92 MHz
Design a Colpitts Oscillator using Op Amps with a frequency fo > 92 MHz
Multisim simulation of colpitts oscillator (using opamp) for frequency 100MHz
Multisim simulation of colpitts oscillator (using BJT) for frequency 100MHz
Using C 210 nF capacitor and other required capacitors, resistors, and ideal op amps, design a low-pass unity-gain Butterworth filter with a cutoff frequency of 40 kHz and is down at least-55 dB at 200 kHz.
Circuit 8 Using a single op amp, design an oscillator which produces a 400 hz output waveform. Carefully adjust the frequency and then show it to your lab instructor who will verify your results. The closer to 400 hz you are, the higher you will score.
i. Draw the circuit (using op-amps) that you would use to generate a square wave. ? ii. Derive expressions for T H, TL, duty cycle and the frequency of the generated square wave. Clearly sketch the different waveforms in your circuit? iii. Let’s assume that in your design you can only use 10k Ω resistors. Choose the values of the other circuit components in your design such that the square wave has a frequency of 1kHz , and a duty...
Using ideal op-amps, design operational amplifier circuits that will yield the following outputs: (a) Vo = 20 Vin (b) Vo = -Vin (c) Vo = Vin (d) Vo = -10Vi1 - 16Vi2
Design an op-amp circuit using 741 op-amps to do the following; Input range: -300mV to 100mV (note the input is 400mVpp sine wave with 100mV offset) output range: 0V to 5V (Note: a -300mV input should generate a 0V output and a 100mV input should generate a +5V output.) Please use the free online versions of Multisim or PartSim.
sing one op-amp (or op-amps) und kilo-Ohm resistors, design a circuit to om the operation with two inputs and one output). Assume ideal op-amps (an 12 volt power supplies). vo - 5(v12 - Vil)
A cyclotron with dee radius 45.0 cm is operated at an oscillator frequency of 11.0 MHz to accelerate protons. (a) What magnitude B of magnetic field is required to achieve resonance? (b) At that field magnitude, what is the kinetic energy of a proton emerging from the cyclotron? MeV Suppose, Instead, that B = 1.58 T. (c) What oscillator frequency is required to achieve resonance now? MHz (d) At that frequency, what is the kinetic energy of an emerging proton?...
1- Using Op Amps, design a Wien Bridge sinusoidal osc illator with 10Hz s fs 10kHz R1 Out In C a сь Measure the amplitude and frequency of the oscillation and graph the waveform. Note, use a 10 turn pot (4K-10K) for R use multisim to simulate the above circuit with photos showing the circuit and results Please provide a brief analysis of the circuit around 250 words. The answer the question belowe Does the clipping occur?+ Briefly explain and...