In case you have any doubts or you did not understand any step please feel free to ask your doubts in the comments section. I would be happy to clarify it
electronics question #3 (5 pts.) A BJT amplifier has the voltage gain of 80, absolute voltage gain of 60, current gain of 40, and source resistance of 1 k2. Find the load resistance (no need to kn...
The Final Project for the ELECTRONICS-1 course for, consists of designing a cascaded BJT Amplifier; using 2 stages. The first stage will be the Common Emitter (CE) Amplifier, the second stage is the Common Collector (CC) Amplifier, as shown in the general diagram below: The overall amplification (voltage gain) Atotal = 98 The input source voltage Vsource is an ideal source(Rs=0 Ohm) with peak voltage 10 mV, and the source frequency fsource =2K Hz The load resistance RL = 47...
An amplifier has an open-circuit voltage gain of 160. With a 10 kΩ load connected, the voltage gain is found to be only 80. Find the output resistance of the amplifier. Ro=
1.14 An amplifier with a voltage gain of +40 dB, an input resistance of 10 kS2, and an output resistance of i kn is used to drive a l-kΩ load. What is the value of Apo? Find the value of the power gain in decibels. 1.14 An amplifier with a voltage gain of +40 dB, an input resistance of 10 kS2, and an output resistance of i kn is used to drive a l-kΩ load. What is the value of...
2. An amplifier has an input resistance R 10k2. When it is driven by a current source of luA with source resistance Rs-100k2, it has a short-circuit output current of 10mA and an open- circuit output voltage of 10V. When driving a load resistance RL-4kΩ at the output, what is 40% the voltage gain Av, current gain Ai, and power gain Ap in dB?
i just need help with B, C, D 3) (24 pts) The BJT amplifier shown below. Please answer the following questions. Consider that B=150 VBE=0.75 V and VT-25mV a) What type of amplifier is this? (Select One) CE CE with RE CB b) Find the DC collector current Ic c) Find the transconductance gain gm d) Find the internal small signal voltage gain Au e) Find the input resistance of the small signal amplifier 1) Find the output resistance of...
2. A CS amplifier is driven by a signal source with Rsie = 100 k2, and has load resistance RL = 100 k.2. Assume CL = Cgs = 0.1 pF, Cgd = 50 fF, gm = 1 mA/V, and r. = 100 k22. (a) Find the midband voltage gain. (b) Use open-circuit time constants to find upper 3-dB frequency fu.
EEET255 Electronics Page 4 of6 QUESTION 3: [25 marks] Figure 3 shows a feedback amplifier circuit R, is the source resistor, R is the feedback resistor and R, is the load resistor. The op-amp has an internal input resistance of R, an intemal output resistance R, and an internal gain of A Apply the "Systematic Analysis" method in this question. Figure 3 3.a State the feedback topology used in the amplifier circuit and which type of feedback amplifier is shown...
Problem Consider a voltage amplifier having a frequency response of the low-pass STC 1ype with a de gain of 60 dB and a 3-dB frequency of 1000 Hz Find the gain in dB at f- 10 Hz, 10kHz, 100 kHz, and 1 MHz Problem For the circuit shown below first, evalusteand the coresponding comer froquency. Second evalmt and the corresponding comer froquency. At the end caloulate overall transfer function T(w)= and reurite it in the standard fom ( and draw...
1. An amplifier has a voltage gain Av equal to 20. An input voltage v of 150 mVs applied to the input of the amplifier. What is the output voltage vo? Rs 2. For the amplifier in Problem 3, assume the input current i is 2 mA, and the output current io is 10 mA. What is the current gain A, ? Assuming the amplifier as described above has an output resistance is 0 ohms, what is the load resistance...
please write neatly 1. The amplifier in Figure 1 has a voltage gain of A 200. input resistance Ri 50ks2, and output resistance Ro-5000. Find the values of R, R3, C, and L so that the oscillation frequency is Amplifier R AV (a) Voltage-controlled voltage source Figure 1 1. The amplifier in Figure 1 has a voltage gain of A 200. input resistance Ri 50ks2, and output resistance Ro-5000. Find the values of R, R3, C, and L so that...