Figure shows the design of the lower end of the member AB in Figure. Use the load shown in...

Figure shows the design of the lower end of the member AB in Figure. Use the load shown in Figure and assume that it is static. Member 1 is made from aluminum alloy 6061-T4; member 2 is made from aluminum alloy 2014-T4; pin 3 is made from aluminum alloy 2014-T6. Perform the following analyses

(a) Evaluate member 1 for safety in tension in the area of the pin holes.

---

(b) Evaluate member 1 for safety in bearing at the pin.

---

(c) Evaluate member 2 for safety in bearing at the pin.

---

(d) Evaluate the pin 3 for safety in bearing.

---

(e) Evaluate the pin 3 for safety in shear

Figure:

                                   FIGURE  Clevis for beam support for Problem.

Figure:

                       

                                          FIGURE  Support for Problem.