We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
443 471 502 Absorbance 360 Wavelength (nm) In the UV-Vis spectrum above, consider the molar absorption...
38. Using the Woodward-Fieser rules, calculate the value of UV-vis absorption maximum wavelength in the UV-vis spectrum for each compounds (heteroannular diene: 214 nm; homoannular diene: 253 nm) end-G Current startA E, E Voltage Potential H3CO (a) (b) (c) Time
1. (a) Why does buta-1,3-diene (max 217 nm) have a longer-wavelength (lower-energy) UV-Vis absorption peak as compared to ethene (max 171 nm)? Include an energy level diagram with your answer. (b) What would you expect to happen as you add on to this structure with additional double bonds? Hint: consider the total number of p atomic orbitals contributing to each molecule, as depicted below. ?-? Ethene Butadiene
Please show work! A solution containing a mixture of the compounds X and Y had an absorbance of 1.06 at 443 nm and an absorbance of 0.909 at 520 nm when measured with a 1.00 cm cell. The molar absorptivities (C) of X and Y at each wavelength are shown in the table. Wavelength (2. nm) Molar Absorptivity (M 'cm ) 3507 443 520 14860 3616 5818 What are the concentrations of X and Y in this mixture? Transmittance (%)...
Table 1. Concentrations of [Fe(Phen),1?, M, in water and UV- vis absorbance values recorded at 2 -505 nm. Concentration of [Fe(Phen)/, M Absorbance 9.500 x 10 0.999 4.250 x 10 0.480 0.219 2.125 10% 1.063 x 10 0.104 0.000 0.003 Table 2. UV-vis absorbance values of [Fe(phen)]* held at 35 °C after mixing with H SO, and recorded at 5 minute intervals (in water at max = 505 nm). Time (minutes) Absorbance 0.997 0.935 0.877 0.823 0.772 0.724 0.680 0.638...
Absorbance of chlorophyll a -Rate of photosynthesis 400 500 600 700 Wavelength of light (nm) The graph above shows the absorption spectrum for chlorophyll a. According to the data, which wavelength of light is most effective in driving photosynthesis? A. 420 nm B. 575 nm C.625 nm D.730 nm
a) If a compound has the wavelength of maximum absorbance of 600 nm, what would happen if all of the samples were measured at a slightly higher wavelength (i.e. 620 nm)? b) When plotting data of concentration vs. absorption of the compound, will the change in wavelength affect the R^2 value of the graph? why or why not? c) Will the change in wavelength affect the molar absorptivity calculated from the graph? why or why not?
can u tell me plzz Refer to the figure of the UV absorption spectra of NAD+ and NADH. What is the optimal wavelength to use in an experiment to detect the production of NADH? Select one: a. 260 nm b 300 nm 1 c. 340 nm d. 360 nin
2. The absorbance of a 2.31 x 10 a wavelength of 266 nm in a 1.00 cm cell. absorptivity at 266 nm. M solution of a compound is 0.822 at Calculate the molar The following absorption data were calculated in-an experiment: 3. Absorbance 0.000 0.090 0.181 0.271 0.361 0.450 0.539 0.627 0.7 Concentration (м) 0.000 1x10-3 2x10-3 3x10 3 4x10-3 5x10~3 6x10-3 7x10-3 8x1 Plot Absorbance vs. Concentration and calculate the molar absorptivity coefficient from the slope if the a)...
(5 questions) Data: Consider the data below for a Beer's Law calibration curve for an aqueous orange nye solution that has mas 450 nm. The solutions used were translucent. The data was collected using a 1.20cm wide test tube cuvette, using 2 = 450 nm. Trial Concentration (M) Absorbance Percent Transmittance 1 0 .0030 0.153 70.3 0.0060 0.312 48.8 0.0090 0.465 34.3 0.0120 0.627 23.6 0.0150 0.771 16.9 For each of the following errors/changes, indicate whether a repeat of the...
1.2 1.0 0.8 0.6 0.4+ 0.2 0+ 300 350 400 450 500 550 600 650 700 Wavelength (nm) The absorption spectrum of a certain red dye is shown above. If a student analyzing the same concentration of this dye neglected to wipe fingerprints off the cuvette before placing it in the spectrophotometer, how would the absorption curve be affected? Absorbance