T=300K, Ni=1E10cm-3 1. [BJT Forward-Active Current] For a npn BJT with cross-section as below: (a) [20%]...

Question

Question

T=300K, Ni=1E10cm-3

Answer 1

Answer #1

Answer 2

Similar Homework Help Questions

3. A silicon npn bipolar transistor is uniformly doped and biased in the forward active region wi...

3. A silicon npn bipolar transistor is uniformly doped and biased in the forward active region with the base-collector junction reverse biased by 2.5 V. The metallurgical base width is 1.5 μm. The emitter, base collector doping concentrations are 5 × 1017, 1016, 2 × 1015 cm-3 respectively. a. At T-300 K, calculate the base-emitter voltage at which the minority carrier electron concentration at x-0 is 20% of the majority carrier hole concentration. At this voltage calculate the minority carrier...
Forward Active Reverse Active Cutoff Saturation 2. The minority carrier distribution in a NPN BJT under forward acti...

Forward Active Reverse Active Cutoff Saturation 2. The minority carrier distribution in a NPN BJT under forward active bias is given in the following questions. On top of the figure, sketch the corresponding new minority carrier concentration when the given condition is changed. (To make the question simple, you may assume the depletion width remains unchanged in all questions. But you have to indicate the new equilibrium minority concentration if they are affected.) 6. a) collector doping is increased by...
A npn BJT has a B = 110 and a base current of iB = 50...

A npn BJT has a B = 110 and a base current of iB = 50 μA. Calculate the collector current and the emitter current. Assume operation in the active region. Express the results in mA. (4 pts.)

An NPN bipolar junction transistor (BJT) is used to turn on and off a 30 Ohm...

An NPN bipolar junction transistor (BJT) is used to turn on and off a 30 Ohm load using an Arduino digital output pin as shown. Assuming the transistor is on, in the saturation region, determine the power delivered to the 30 Ohm load. The voltage drop across the collector-emitter junction of the transistor is 0.2 Volts. +5 v 1308 ARDUINO SV UNO mne гоо са Vce=0.2 v Saturation VBE = 0.7V in active & Saturation regions
The NPN transistor in the circuit shown haes B-60 Assuming that the BJT is operating in the deep ...

answer i-iv please The NPN transistor in the circuit shown haes B-60 Assuming that the BJT is operating in the deep saturation mode ie. VCEsat-02y and VBE-07V ßforced-10. Question 3: 20% p-60) Assuming that the BJT is operating in the deep Rg i) Calculate collector current, Ic. (4%) ii) Calculate voltage VBB and base current,IB(6%) iii) If we keep VBB and Rc the same, i.e. at 1k2, what is the minimum value of RB to restore the transistor beta to...
2. (15 pts) An npn bipolar junction transistor is biased in the forward-active region. The common-base...

2. (15 pts) An npn bipolar junction transistor is biased in the forward-active region. The common-base current gain, α 0.95. The input emitter current is IE-4.6 mA. a) Calculate the collector current Ic b) Calculate the common-emitter current gain, B c) Calculate the base current IB IB

question 3 and 4 Problem2 (30 points) Consider an npn bipolar transistor with the following characteristics...

question 3 and 4 Problem2 (30 points) Consider an npn bipolar transistor with the following characteristics Base Collector Emitter Na-5x 1016 cm3 Ng- 1015 cm3 N1018 cm3 DC- 12 cm-/sec DE 8 cm-/sec (diff coef.) DB 15 cm-/sec sec TEO 108 sec (life time) tB0 5x 10 tCo 10 sec xp 0.7 um (Base width) xg 0.8 um (emitter width) D Remember D/u= KT /q, and L n.p n.p A forward bias of 0.5 V is applied to the emitter-base...
1. An npn transistor is operating in the forward-active region with a base current of 3...

1. An npn transistor is operating in the forward-active region with a base current of 3 μA. It is found that IC = 225 μA for VCE = 5 V and IC = 265 μA for VCE = 10 V. What are the values of β and VA for this transistor
Problem 2. A silicon NPN bipolar transistor has the following specifications: Emitter: N+: ND =1018 cm-3...

Problem 2. A silicon NPN bipolar transistor has the following specifications: Emitter: N+: ND =1018 cm-3 , base: p-type, NA=1015 cm-3, collector: N-type, ND=5x1015 cm-3 . 1. Draw the energy band diagram of the transistor at thermal equilibrium, 2. If the transistor is biased at Normal Active Mode, emitter-base junction forward biased with 1 V, and collector-base junction is reverse biased with 4V, draw the energy band diagram.

Please explain part A in details thx! Question 3 An n'pn Si BJT is shown in Figure Q3(a). The emitter is heavily doped with 1020 cm3 whereas the base and collector are lightly doped with 5x1018 a...

Please explain part A in details thx! Question 3 An n'pn Si BJT is shown in Figure Q3(a). The emitter is heavily doped with 1020 cm3 whereas the base and collector are lightly doped with 5x1018 and 3x1018, respectively. The lengths of emitter, base, and collector are 0.5um, 0.2um, and 0.5 um.. The dielectric constant of silicon is 11.8 and the intrinsic carrier concentration at 300 K is 1.5x1010 cm3. Assume that a 0.026 eV at 300 K. 0.99, e...