You wish to have sufficient TSA to make 10 pour plates. Each plate holds approximately 20...
-
You wish to have sufficient TSA to make 10 pour plates. Each plate holds approximately 20 ml of agar. The instructions on the container are that 40 grams are to be used to make a liter. How much dehydrated medium do you need?
Homework Answers
Answer:
So, from the question it is given that:
For 1000 ml, we require = 40 grams of agar
Therefore, for For 20 ml , we require = (40/1000 )* 20 = 0.8 grams
And we need to make 10 pour plates each with 20 ml of agar, so we would require = 0.8 x 10 = 8 grams of the dehydrated medium.
Therefore, 8 grams of the dehydrated medium would be required.
Add Answer to:
You wish to have sufficient TSA to make 10 pour plates. Each
plate holds approximately 20...
You are given a mixed culture of two organisms in a small tube of TSB.
You are given a mixed culture of two organisms in a small tube of TSB. These two organisms include a Gram-negative strain (your bacterial strain to identify) and a Gram-positive strain (a contaminant). Your first task is to isolate these organisms which will help you identify which Gram-negative strain you are working with. 1) You inoculate two streak plates on TSA media and MacConkey Agar using aseptic technique. For each medium, state whether the medium is selective, differential, or neither and...
please help me with letter B. Value Ulla ination of Living EXERCISE 3: MICROE b. Holding...
please help me with letter B.
Value Ulla ination of Living EXERCISE 3: MICROE b. Holding the flask at an angle, remove the stop- per with the fourth and fifth fingers of your oth- er hand. Heat the mouth of the flask by passing it through the flame three times (FIGURE 2a). Why is it necessary to keep the flask at an an- gle through this procedure? (a) Remove theflask. c. Remove the cover from the first dish with the...
You have an assay that has a range of 20-500 ug in a 500 ul sample....
You have an assay that has a range of 20-500 ug in a 500 ul sample. What is the concentration range for the samples used in the standard curve? You have one sample that you wish to run to determine the molecular content and have approximately 500 mg in two ml. How will you dilute (or not) to do this assay?
Hello, just wanted to check my answers. Answer as many as you like/can. Thankyou. 1) Four...
Hello, just wanted to check my answers. Answer as many as you like/can. Thankyou. 1) Four grams of soil are added to 36 ml sterile water and mixed well. 0.1 ml of this mix was added to 9.9 ml sterile water. This was diluted by 4 successive 1/10 dilutions. 1.0 ml from the last dilution was used to prepare a pour plate. After incubation 289 colonies were counted. Calculate the # CFU/g soil. 2) A 0.1 ml aliquot of a...
You have to make 100 mL of a solution of GABA at a concentration of 10-6...
You have to make 100 mL of a solution of GABA at a concentration of 10-6 M. How much GABA (in µg) do you need?
Please show how to do these enumeration questions by showing the work. What is the dilution...
Please show how to do these enumeration questions by showing the work. What is the dilution factor if you add 625 µL of culture to 4.375 mL of dilution medium? You count the 10-3 dilution of a yeast suspension using the 1/25 mm2 boxes : you find 45 cells in box 1, 15 cells in box 2, 42 cells in box 3, 23 cells in box 4, and 26 cells in box 5. a) What is the original concentration of...
1. to 10. Describe stepwise how would you prepare 1 L of a defined solid medium...
1. to 10. Describe stepwise how would you prepare 1 L of a defined solid medium that requires vitamins B1 and B2 and penicillin. The recipe you found only has the final composition: Solidifying agent Salts 1.5% Agar 0.3% (22mM) Potassium Phosphate (KH2PO4) 0.6% (22mM) Sodium Phosphate (Na2HPO4) 0.5% (85mM) Sodium Chloride (NaCl) 0.1% Ammonium Chloride (NH4Cl) 2mM Magnesium Sulfate (MgSO) 0.1mM Calcium Chloride (CaCb) 0.4% Glucose (4.0 g/L) Carbon source 1 HM Vitamin B1 1 HM Vitamin B12 50...
10. If you pour water in a glass cylinder, you see upper and lower meniscus. If...
10. If you pour water in a glass cylinder, you see upper and lower meniscus. If you use a plastic cylinder, the surface appears flat. Which of the following properties of water is responsible for the formation of the meniscus? High heat of vaporization Cohesion and Adhesion Excellent solubility maintenance of pH 17. If you were to make 200 mL of 3% sugar solution, how much sugar would you have to weigh? 2 g 12 g 6 g 1.5 g...
QUESTION 1 Imagine you are preparing an industrial enzyme assay. The protocol says to add 20...
QUESTION 1 Imagine you are preparing an industrial enzyme assay. The protocol says to add 20 mL of 100 mM NaCl to your assay, and the final volume of the assay is 100 ml. What is the working concentration of NaCl? The number of significant digits you include in your answer doesn't matter, but it must be in units of mM. QUESTION 2 Imagine you are preparing an enzyme assay that requires a working concentration of 10 mM NaCl. If...
2 What is the minimum genotype of a recombinant cell that grew on minimal media supplemented...
2 What is the minimum genotype of a recombinant cell that grew on minimal media supplemented with arginine, methionine and the antibiotic tetracycline but lacking the essential amino acid isoleucine 3 How would you determine if your recombinant cells had also acquired the tryptophan gene from the Hart Complete the following table indicating which of the organisms (F and/or Hfr used in this experiment would be expected to grow on the given media. Unless specified, MMD is just minimal medium...
please help me with letter B.
Value Ulla ination of Living EXERCISE 3: MICROE b. Holding the flask at an angle, remove the stop- per with the fourth and fifth fingers of your oth- er hand. Heat the mouth of the flask by passing it through the flame three times (FIGURE 2a). Why is it necessary to keep the flask at an an- gle through this procedure? (a) Remove theflask. c. Remove the cover from the first dish with the...
1. to 10. Describe stepwise how would you prepare 1 L of a defined solid medium that requires vitamins B1 and B2 and penicillin. The recipe you found only has the final composition: Solidifying agent Salts 1.5% Agar 0.3% (22mM) Potassium Phosphate (KH2PO4) 0.6% (22mM) Sodium Phosphate (Na2HPO4) 0.5% (85mM) Sodium Chloride (NaCl) 0.1% Ammonium Chloride (NH4Cl) 2mM Magnesium Sulfate (MgSO) 0.1mM Calcium Chloride (CaCb) 0.4% Glucose (4.0 g/L) Carbon source 1 HM Vitamin B1 1 HM Vitamin B12 50...
QUESTION 1 Imagine you are preparing an industrial enzyme assay. The protocol says to add 20 mL of 100 mM NaCl to your assay, and the final volume of the assay is 100 ml. What is the working concentration of NaCl? The number of significant digits you include in your answer doesn't matter, but it must be in units of mM. QUESTION 2 Imagine you are preparing an enzyme assay that requires a working concentration of 10 mM NaCl. If...
2 What is the minimum genotype of a recombinant cell that grew on minimal media supplemented with arginine, methionine and the antibiotic tetracycline but lacking the essential amino acid isoleucine 3 How would you determine if your recombinant cells had also acquired the tryptophan gene from the Hart Complete the following table indicating which of the organisms (F and/or Hfr used in this experiment would be expected to grow on the given media. Unless specified, MMD is just minimal medium...
Most questions answered within 3 hours.
-
Label the image to renview the relative resistance of various
microbes to microbial control agents
asked 6 minutes ago -
PLEASE DO BOTH #5 AND #6.
The purpose of the project is to perform a timing...
asked 36 seconds from now -
Power and privilege is best defined as:
a system in which two or more parties work...
asked 2 minutes ago -
Describe the process of nitrogen excretion in the body. List 4
steps and explain each step
asked 2 minutes ago -
Hewlett Packard is considering an investment project that
requires an initial investment of $20 million. The...
asked 7 minutes ago -
9.
While a ball falls to the ground, it accelerates continuously and
so increases its momentum....
asked 22 minutes ago -
The wave functions for two harmonic waves are given by
D1(x,t)
=(0.3m)sin(2.0x−3.0t),
D2(x,t)
=(0.3m)sin(2.0x−3.0t+π/2)
where x...
asked 18 minutes ago -
1 [Run Lengths] Write a function (in Python and numpy) with the
following specification def run_lenths(n,...
asked 17 minutes ago -
Problem 5-22
Yield to Maturity and Yield to Call
Arnot International's bonds have a current market...
asked 19 minutes ago -
Determine the amount of manufacturing overhead given the
following informations:
Depreciation on a factory building
$2,600...
asked 20 minutes ago -
On April 1, 2018, Windel Corporation issued bonds with
detachable warrants.
Information related to these bonds...
asked 42 minutes ago -
public enum Rating {
GENERAL(0),
PARENTALGUIDANCE(1),
MATURE(2);
asked 47 minutes ago