heat exchanger has water in the outer conduit and ethylene glycol in the inner. It is...
heat exchanger has water in the outer conduit and ethylene glycol in the inner. It is desired to have a Reynolds number of 1000 in the inner conduit and 15000 in the outer conduit. The inner conduit is 5mm inside diameter and the outer conduit is 12mm inside diameter. Specify the pressure drop per unit length in the each conduit (Pa/m). The inner conduit has a wall thickness of 0.75 mm.
Homework Answers
Add Answer to:
heat exchanger has water in the outer conduit and ethylene glycol in the inner. It is...
Oil of unknown properties is heated in a shell-and-tube heat exchanger with one shell pass and...
Oil of unknown properties is heated in a shell-and-tube heat exchanger with one shell pass and 20 tube passes. The oil flows through the shell, and hot water flows inside the single copper tube that has an inner diameter of 20 mm, a wall thickness of 2 mm, and a length of 3 m per pass. The water enters at 360 K at a mass flow rate of 0.2 kg/s and leaves at 300 K. The inlet and outlet temperatures...
A concentric tube, parallel heat exchanger is used to warm cold well water running on the...
A concentric tube, parallel heat exchanger is used to warm cold well water running on the inside pipe from 10°C to 25°C overa meter of pipe using steam running through the outside pipe that enters the system at 140°C and leaves at 100°C. The inside pipe is made of copper and has an inner diameter of 4 cm, with a wall thickness of 0.25 cm. The outside pipe is made of a very-well insulating material, has a diameter of 7...
A concentric tube heat exchanger for cooling lubricating oil consists of a thin-walled inner tube of...
A concentric tube heat exchanger for cooling lubricating oil
consists of a thin-walled inner tube of 25 mm diameter carrying
water and an outer tube of 45 mm diameter carrying the oil. The
exchanger operates in countercurrent flow with an overall heat
transfer coefficient of 55 W/m2 K and the tabulated average
properties given below. Mass flow rates of oil and water are both
0.1 kg/s, oil enters the exchanger at 100°C, and water enters the
exchanger at 30°C. (a)...
Problem 4: Consider the heat exchanger design illustrated. Hot air flows at speed of r0.6 m/s thr...
Problem 4: Consider the heat exchanger design illustrated. Hot air flows at speed of r0.6 m/s through the center pipe. The center pipe has an outer diameter of D=7 cm and length 4-2 m Cold water flows at 20-25 cm3/s through a smaller helical pipe having an outer diameter d = 1 cm and wall thickness of mm. The helical pipe is wrapped around the center pipe to form a heat exchanger. The center pipe has a thermal conductivity of...
A shell and tube heat exchanger with one shell pass and two tube passes is used...
A shell and tube heat exchanger with one shell pass and two tube passes is used to heat 8.82 kg/s of fluid from 15.6 °C to 60 °C by using saturated steam at 150 kPa. The steam is condensing on the outside of the tubes with h= 15 kW/m2.K. There are 50 tubes with an outside diameter of 1.91 cm and a wall thickness of 0.211 cm. If the fouling coefficient on the inside of the tubes is 5678 W/m2.K,...
Two-pipe concentric concentric) for cooling the engine oil with the help of a water stream in...
Two-pipe concentric concentric) for cooling the engine oil with the help of a water stream in a large diesel engine a reverse (opposite) flow heat exchanger is used. Water at a flow rate of 0.3 kg/h from inside pipe with an inside diameter of 56 mm It flows. The inner pipe is made of stainless steel with a heat transmission coefficient of 16 W/mc and is meat (wall its thickness is 3 mm. Apart from this there is another pipe...
The heat exchanger in a heat lung machine is constructed so that blood flows through an...
The heat exchanger in a heat lung machine is constructed so
that blood flows through an array of tubes controlled temperature
water circulated through an outer exterior shell.
e heat exchanger in a heat lung machine is constructed so that blood flows through an array of tubes with controlled temperature water circulated through an outer exterior shell. Although the temperature of the blood varies as it passed through the heat exchanger, during the cool down cycle when a patient is...
[10] Design Problem As shown in the figure below, a double-pipe parallel-flow heat exchanger is used...
[10] Design Problem As shown in the figure below, a double-pipe parallel-flow heat exchanger is used to heat cold fluid which is water (Cp = 4180 J/(kg.K), p = 1000 kg/m) from 20°C to 80°C at a rate of 0.15 kg/s. The heating is to be accomplished by hot fluid, which is geothermal water (Cp = 4310 J/(kg.K), p = 1050 kg/m²) available at 130°C at a mass flow rate of 0.25 kg/s. The inner tube has an inner diameter...
A simple counter flow heat exchanger consists of two co-axial tubes with hot process water passing...
A simple counter flow heat exchanger consists of two co-axial tubes with hot process water passing through the inner tube and clean water through the annular space between the inner and outer tubes. The clean water enters at 20°C and leaves at 50°C. The process water enters at 90°C and leaves at 40°C. The mass flowrate of the process water is 3 kgs-1. The inner tube diameter is 30 mm and the outer tube diameter is 50 mm. Take the...
1 CPD4701 Assignment 2/2019 Question 2 shell and-tube heat exchanger was designed for the following service: Cold strea...
1 CPD4701 Assignment 2/2019 Question 2 shell and-tube heat exchanger was designed for the following service: Cold stream Hot stream Crude Oil Fluid Cooling water Tube side Stream allocation Shell side Mass flow rate (kg/s) 110 30 Inlet temperature (C) 90 Outlet temperature (C) Heat capacity (J/kg K) Density (kg/m2) Viscosity (Pa-s) Thermal conductivity (W/m-K) Fouling factor (m2 CW) 40 50 2177 4187 787 995 0.72-10 1.89-103 0.122 0.59 0.0002 0.0004 The shell and tube heat exchanger has the following...
Oil of unknown properties is heated in a shell-and-tube heat exchanger with one shell pass and 20 tube passes. The oil flows through the shell, and hot water flows inside the single copper tube that has an inner diameter of 20 mm, a wall thickness of 2 mm, and a length of 3 m per pass. The water enters at 360 K at a mass flow rate of 0.2 kg/s and leaves at 300 K. The inlet and outlet temperatures...
A concentric tube heat exchanger for cooling lubricating oil
consists of a thin-walled inner tube of 25 mm diameter carrying
water and an outer tube of 45 mm diameter carrying the oil. The
exchanger operates in countercurrent flow with an overall heat
transfer coefficient of 55 W/m2 K and the tabulated average
properties given below. Mass flow rates of oil and water are both
0.1 kg/s, oil enters the exchanger at 100°C, and water enters the
exchanger at 30°C. (a)...
Problem 4: Consider the heat exchanger design illustrated. Hot air flows at speed of r0.6 m/s through the center pipe. The center pipe has an outer diameter of D=7 cm and length 4-2 m Cold water flows at 20-25 cm3/s through a smaller helical pipe having an outer diameter d = 1 cm and wall thickness of mm. The helical pipe is wrapped around the center pipe to form a heat exchanger. The center pipe has a thermal conductivity of...
A shell and tube heat exchanger with one shell pass and two tube passes is used to heat 8.82 kg/s of fluid from 15.6 °C to 60 °C by using saturated steam at 150 kPa. The steam is condensing on the outside of the tubes with h= 15 kW/m2.K. There are 50 tubes with an outside diameter of 1.91 cm and a wall thickness of 0.211 cm. If the fouling coefficient on the inside of the tubes is 5678 W/m2.K,...
Two-pipe concentric concentric) for cooling the engine oil with the help of a water stream in a large diesel engine a reverse (opposite) flow heat exchanger is used. Water at a flow rate of 0.3 kg/h from inside pipe with an inside diameter of 56 mm It flows. The inner pipe is made of stainless steel with a heat transmission coefficient of 16 W/mc and is meat (wall its thickness is 3 mm. Apart from this there is another pipe...
The heat exchanger in a heat lung machine is constructed so
that blood flows through an array of tubes controlled temperature
water circulated through an outer exterior shell.
e heat exchanger in a heat lung machine is constructed so that blood flows through an array of tubes with controlled temperature water circulated through an outer exterior shell. Although the temperature of the blood varies as it passed through the heat exchanger, during the cool down cycle when a patient is...
[10] Design Problem As shown in the figure below, a double-pipe parallel-flow heat exchanger is used to heat cold fluid which is water (Cp = 4180 J/(kg.K), p = 1000 kg/m) from 20°C to 80°C at a rate of 0.15 kg/s. The heating is to be accomplished by hot fluid, which is geothermal water (Cp = 4310 J/(kg.K), p = 1050 kg/m²) available at 130°C at a mass flow rate of 0.25 kg/s. The inner tube has an inner diameter...
A simple counter flow heat exchanger consists of two co-axial tubes with hot process water passing through the inner tube and clean water through the annular space between the inner and outer tubes. The clean water enters at 20°C and leaves at 50°C. The process water enters at 90°C and leaves at 40°C. The mass flowrate of the process water is 3 kgs-1. The inner tube diameter is 30 mm and the outer tube diameter is 50 mm. Take the...
1 CPD4701 Assignment 2/2019 Question 2 shell and-tube heat exchanger was designed for the following service: Cold stream Hot stream Crude Oil Fluid Cooling water Tube side Stream allocation Shell side Mass flow rate (kg/s) 110 30 Inlet temperature (C) 90 Outlet temperature (C) Heat capacity (J/kg K) Density (kg/m2) Viscosity (Pa-s) Thermal conductivity (W/m-K) Fouling factor (m2 CW) 40 50 2177 4187 787 995 0.72-10 1.89-103 0.122 0.59 0.0002 0.0004 The shell and tube heat exchanger has the following...
Most questions answered within 3 hours.
-
convert grams into vloume with the density of water being at
.997514 g/cm^3 at 23.1 Celsuis...
asked 1 hour ago -
Foreman company obtained a $20,000, 6% loan on May 1, 2018.
Principal and interest will be...
asked 1 hour ago -
5. Problem 11.05 (Discounted Payback)
eBook
Project L costs $60,000, its expected cash inflows are $14,000
per...
asked 1 hour ago -
1. Which of the following is true about politics and health
organizations?
A. Health organizations are...
asked 2 hours ago -
A space vehicle is coasting at a constant velocity of 18.1 m/s
in the +y direction...
asked 3 hours ago -
5) Use the following balanced equation to answer questions
(a)-(i).
3 Cu(s) + 8 HNO3(aq) →...
asked 2 hours ago -
A three-year maturity bond with a 12% annual coupon rate is
currently traded at par $1000...
asked 3 hours ago -
1.
What is the minimum volume to use in the Spec 20 cuvette in order
to...
asked 3 hours ago -
A builder wants to install wall-to-wall carpeting in a living
room of length 8.87 m and...
asked 3 hours ago -
Organizational change can produce anxiety in those affected by
the change. In what ways can change...
asked 3 hours ago -
Ozone in the atmosphere may react with nitric oxide.
From the following data, calculate the DG...
asked 3 hours ago -
Steven Long, a bond analyst, is analyzing a convertible bond.
The characteristics of the bond are...
asked 3 hours ago