What is the term for a set of flip-flops and the gates that implement their state...
What is the term for a set of flip-flops and the gates that implement their state transitions?
| 1. |
(a) Full Adder |
|
| 2. |
(b) Moore machine |
|
| 3. |
(c) Register |
|
| 4. |
(d) Decoder |
|
| 5. |
(e) None of (a) through (d) is the correct answer. |
A D flip-flop has a D latch and a SR latch. The D latch is connected directly to the clock (no inverter). This type of flip-flop will be able to change state when the clock is
| 1. |
(a) 0 |
|
| 2. |
(b) 1 |
|
| 3. |
(c) Transitioning from 0 to 1 |
|
| 4. |
(d) Transitioning from 1 to 0 |
|
| 5. |
(e) None of (a) through (d) is the correct answer |
Instead of the two gate design, we will use four gates to implement an SR latch - this design features a control input.
what type of gate would be used?
| 1. |
(a) AND |
|
| 2. |
(b) OR |
|
| 3. |
(c) NAND |
|
| 4. |
(d) NOR |
|
| 5. |
(e) None of (a) through (d) is the correct answer. |
Homework Answers
Add Answer to:
What is the term for a set of flip-flops and the gates that
implement their state...
Use the gated SR latch design with only NAND gates to design a gated SR flip–flop....
Use the gated SR latch design with only NAND gates to design a gated SR flip–flop. The stored bit Q can only change on the positive edge (rising edge) of the clock cycle. Draw the circuit using only logic gates and create a symbol for the flip–flop you designed.
QUESTION UNE (10 MARKS 1. A set of three D-flip flops a, b and care connected...
QUESTION UNE (10 MARKS 1. A set of three D-flip flops a, b and care connected as shown in figure 1. [Note that:Flip flop A reads Data on either edge of the clock] DF I Clock - Cik 0 Dota el e of a Fig. 1. A circuit of three D-flip flops 1.1.State one operational difference between flip flop B and C. 11 MARKS 1.2.Complete the timing diagram in figure 2 by giving the state of each flip-flop [Use the...
TIMING Consider the following ciru. The clock connections to the flip-flops are not shown (both flip-flops...
TIMING Consider the following ciru. The clock connections to the flip-flops are not shown (both flip-flops are clocked by the same clock). Y1 D a Assume the following Delay of each AND gate: 1 ns Delay of each inverter 04 ns Set up time of each flip-flop: 0.1 ns Hold time of each flip-flop: 0 ns Clk-to-Q delay of each fip-flop: 0.3 ns a) What is the maximum frequency of the clock in this cicuit (in MHz)? b) Suppose the...
a) Draw an SR-latch using only NAND gates. Label each input and output, and label all...
a) Draw an SR-latch using only NAND gates. Label each input and output, and label all wires with a name if the wire does not connect to any input or output b) Describe the behavior of the latch when S and R are both 0. What is the output of each gate? c) Assuming that the latch starts with S = R = 0, write down the sequence of what happens when R = 1. Discuss changes at each point...
Done 01. When an inverter is placed between both inputs of an SR. flip-lop, the resulting flip-fo...
digital system solve Q3andQ4
Done 01. When an inverter is placed between both inputs of an SR. flip-lop, the resulting flip-fop is a (a) JK flip-flop (b) T flip-lop (c) Master Slave JK flip-flop (d) D flip-flop 02. A D flip-flop utilizing a Positive-Giate-Triggered (PGT) Clock is in the CLEAR" stae Which of the following input actions will cause it to change states? NGT stands for Negative-Gate-Triggered (a) CLOCK-NGT, D-O (b) CLOCK-PGT, D- (c) CLOCK- NGT: D- (d) CLOCK- PGT,...
a) (5 marks) Explain the difference between a latch, a gated latch and a flip flop....
a) (5 marks) Explain the difference between a latch, a gated latch and a flip flop. b) (5 marks) A gated SR latch has the following schematic diagram CLK a) Draw a timing diagram showing the Q and Q outputs for the following sequence of inputs: CLK R Assume that the initial state of the outputs is Q 0 and Q 1 c) (5 marks) Draw a schematic diagram for a rising edge-triggered master-slave D flip- flop built using two...
5.4 2um 4-34. Design a negative-edge-triggered flip-flop. The flip flop has three inputs; these are Data,...
5.4 2um
4-34. Design a negative-edge-triggered flip-flop. The flip flop has three inputs; these are Data, Clock, and Enable. If, at the negative edge of the clock, the enable input equals to 0, then the state at Data input is stored in the flip-flop. If, at the negative edge of clock, Enable is in 1 state, then the current stored value in the flip-flop is held. Design the flip-flop using only SR latches, AND gates, and NOT gates.
4-34. Design...
A. Design a circuit using D flip-flops that will generate the sequence 0, 0, 1, 0,...
A. Design a circuit using D flip-flops that will generate the
sequence 0, 0, 1, 0, 1, 1 and repeat. Do this by designing a
counter for any sequence of states such that the first flip-flop
takes on this sequence. There are many correct answers, but do not
duplicate states, because each state can have only one next
state.
B. A pulse-generating circuit generates eight repetitive pulses
as shown in the figure. Implement the pulse-generating circuit
using a binary counter...
Q D Clock Clk Q Clock Qb Q Qa Q Q Multiple type of flip-flops Circuit...
Q D Clock Clk Q Clock Qb Q Qa Q Q Multiple type of flip-flops Circuit The figure above shows a circuit that use three different types of D flip-flops: a) D latch b) Rising-edge D flip-flop c) Falling-edge flip-flop For each one of the flip-flops enter their output for the times t1.t2.t3.t4 Assume that initially all outputs are '0' D
hi i need answers for nos. 18-28. 1. In a counter, a flip-flop output 10. A...
hi i need answers for nos. 18-28.
1. In a counter, a flip-flop output 10. A is a group of flip-flops, each one of which transition serves as a source for triggering other flip-flops, not by the common clock pulses. shares a common clock and is capable of storing one bit of information. A) RAM B) latch A ripple Cring (rather than signal transitions) are referred to as B synchronous D binary C) counter D) register 11. The Characteristic Equation...
QUESTION UNE (10 MARKS 1. A set of three D-flip flops a, b and care connected as shown in figure 1. [Note that:Flip flop A reads Data on either edge of the clock] DF I Clock - Cik 0 Dota el e of a Fig. 1. A circuit of three D-flip flops 1.1.State one operational difference between flip flop B and C. 11 MARKS 1.2.Complete the timing diagram in figure 2 by giving the state of each flip-flop [Use the...
TIMING Consider the following ciru. The clock connections to the flip-flops are not shown (both flip-flops are clocked by the same clock). Y1 D a Assume the following Delay of each AND gate: 1 ns Delay of each inverter 04 ns Set up time of each flip-flop: 0.1 ns Hold time of each flip-flop: 0 ns Clk-to-Q delay of each fip-flop: 0.3 ns a) What is the maximum frequency of the clock in this cicuit (in MHz)? b) Suppose the...
digital system solve Q3andQ4
Done 01. When an inverter is placed between both inputs of an SR. flip-lop, the resulting flip-fop is a (a) JK flip-flop (b) T flip-lop (c) Master Slave JK flip-flop (d) D flip-flop 02. A D flip-flop utilizing a Positive-Giate-Triggered (PGT) Clock is in the CLEAR" stae Which of the following input actions will cause it to change states? NGT stands for Negative-Gate-Triggered (a) CLOCK-NGT, D-O (b) CLOCK-PGT, D- (c) CLOCK- NGT: D- (d) CLOCK- PGT,...
a) (5 marks) Explain the difference between a latch, a gated latch and a flip flop. b) (5 marks) A gated SR latch has the following schematic diagram CLK a) Draw a timing diagram showing the Q and Q outputs for the following sequence of inputs: CLK R Assume that the initial state of the outputs is Q 0 and Q 1 c) (5 marks) Draw a schematic diagram for a rising edge-triggered master-slave D flip- flop built using two...
5.4 2um
4-34. Design a negative-edge-triggered flip-flop. The flip flop has three inputs; these are Data, Clock, and Enable. If, at the negative edge of the clock, the enable input equals to 0, then the state at Data input is stored in the flip-flop. If, at the negative edge of clock, Enable is in 1 state, then the current stored value in the flip-flop is held. Design the flip-flop using only SR latches, AND gates, and NOT gates.
4-34. Design...
A. Design a circuit using D flip-flops that will generate the
sequence 0, 0, 1, 0, 1, 1 and repeat. Do this by designing a
counter for any sequence of states such that the first flip-flop
takes on this sequence. There are many correct answers, but do not
duplicate states, because each state can have only one next
state.
B. A pulse-generating circuit generates eight repetitive pulses
as shown in the figure. Implement the pulse-generating circuit
using a binary counter...
Q D Clock Clk Q Clock Qb Q Qa Q Q Multiple type of flip-flops Circuit The figure above shows a circuit that use three different types of D flip-flops: a) D latch b) Rising-edge D flip-flop c) Falling-edge flip-flop For each one of the flip-flops enter their output for the times t1.t2.t3.t4 Assume that initially all outputs are '0' D
hi i need answers for nos. 18-28.
1. In a counter, a flip-flop output 10. A is a group of flip-flops, each one of which transition serves as a source for triggering other flip-flops, not by the common clock pulses. shares a common clock and is capable of storing one bit of information. A) RAM B) latch A ripple Cring (rather than signal transitions) are referred to as B synchronous D binary C) counter D) register 11. The Characteristic Equation...
Most questions answered within 3 hours.
-
Consider the quantum number sets listed below.
What is the name of the smallest element for...
asked 15 minutes ago -
In python,write a function nameSet(first, last) that takes a
person's first and last names as input,...
asked 2 hours ago -
How do you think we should value management? Specifically how
might we try to determine MRPL...
asked 2 hours ago -
Suppose the Central Bank of Turkey starts to pay
interest on reserves. Under what circumstances this...
asked 2 hours ago -
For Bergson the concept of Being contains less reality than does
the concept of Becoming. True...
asked 3 hours ago -
What is the hydroxide ion concentration, [OH-], in a solution
with a hydronium ion concentration, [H3O+]...
asked 3 hours ago -
What species is the reducing agent in the following
equation?
Mg(s) + 2HCl (aq) --> MgCl2(aq)...
asked 3 hours ago -
A 50g ice cube is taken out of a freezer at 0 degrees Celsius
and put...
asked 5 hours ago -
How do ratios help you determine trends? What specific
information do managers look at? Is there...
asked 5 hours ago -
A wavelength of 514 nm is used to find an unknown diffraction
grating. If the separation...
asked 5 hours ago -
Use the central limit theorem to find the mean and standard
error of the mean of...
asked 5 hours ago -
You will be given a file that will contain averages for classes
which are divided into...
asked 5 hours ago