Use the frequency-shift rule to find the spectrum of the signal x(t) = s(t) cos(2π(770, 000)t)...
Use the frequency-shift rule to find the spectrum of the signal x(t) = s(t) cos(2π(770, 000)t) ,
where s(t) = 7 − 3 cos(2π(1000)t + π/7).
I know the relative "definition" of the frequency shift rule, I am just very confused as to how to apply it.
Homework Answers
Add Answer to:
Use the frequency-shift rule to find the spectrum of the signal
x(t) = s(t) cos(2π(770, 000)t)...
Power Spectrum of AM A baseband message signal is given byWn (t)-5 cos 2π 2500t +...
Power Spectrum of AM A baseband message signal is given byWn (t)-5 cos 2π 2500t + 4 cos 2π 5500. An AM waveform carrying this message g(t)-50[1 + μ m(t) mp]cos 2π5x 109, where mp s the peak value of m(t a) Plot (by hand) the power spectrum S (f) of the AM waveform g(t) with 0.6 (You can get help with this from the handout A Power Spectrum Primer. See the section "Finding the Power Spectrum of a Periodic...
Given the following signal: s(t) = 10 + 10 cos(2π.300t) cos(2π.700t)
Given the following signal: s(t) = 10 + 10 cos(2π.300t) cos(2π.700t) Answer the following questions: Use the following trigonometric identity and simplify s(t). cos A.cosB = 1/2cos(A-B) + 1/2cos(A+B) (a) Find the spectrum of the s(t) signal. (b) Find the Bandwidth (B) of the s(t) signal.
Q1) Given an analog signal X(t) = 3 cos (2π . 2000t) + 2 cos (2π...
Q1) Given an analog signal X(t) = 3 cos (2π . 2000t) + 2 cos (2π . 5500t) sampled at a rate of 10,000 Hz, a. Sketch the spectrum of the sampled signal up to 20 kHz; b. Sketch the recovered analog signal spectrum if an ideal lowpass filter with a cutoff frequency of 4 kHz is used to filter the sampled signal in order to recover the original signal ; c. Determine the frequency/frequencies of aliasing noise . Q2)...
Sketch the frequency spectrum of he following signal and indicate the complex magnitude of each. All...
Sketch the frequency spectrum of he following signal and
indicate the complex magnitude of each. All amplitudes must be
positive
Determine fundamental frequency and period
*all phases need to be written in terms of pi between
-pi and pi.
Sketch the frequency spectrum of the following signal and indicate the complex magnitude of each frequency component Manipulate phase as necessary to plot all components of the spectrum with positive amplitudes: x(t) = 14 cos( 1 60mt-π/4) + 5 cos(280mt-2π/3) -cos(600πt...
A wireless service provider transmits a signal s(t) = 5 cos(2π fc t) to a receiver,...
A wireless service provider transmits a signal s(t) = 5 cos(2π fc t) to a receiver, where fc is a variable carrier frequency. The impulse response of the channel linking transmitter and receiver is c(t) = 0.80δ(t − Td ) − 0.47δ(t − T1 ) where Td = 270 nsec, T1 = 430 nsec, and “nsec” = 10 − 9 sec. (a) Compute the simplest math expression for the magnitude-squared frequency response |C(f)|2. (b) Suppose the service provider is allocated...
A wireless service provider transmits a signal s(t) = 5 cos(2π fc t) to a receiver,...
A wireless service provider transmits a signal s(t) = 5 cos(2π fc t) to a receiver, where fc is a variable carrier frequency. The impulse response of the channel linking transmitter and receiver is c(t) = 0.80δ(t − Td ) − 0.47δ(t − T1 ) where Td = 270 nsec, T1 = 430 nsec, and “nsec” = 10 − 9 sec. (a) Compute the simplest math expression for the magnitude-squared frequency response |C(f)|2. (b) Suppose the service provider is allocated...
Consider an AM system. The message signal is given by cos(1000t) volts. The modulated signal is (0.5+acos(1000m))cos(2π.) volts, where α is a positive coefficient, and fe is the carrier frequency. (a...
Consider an AM system. The message signal is given by cos(1000t) volts. The modulated signal is (0.5+acos(1000m))cos(2π.) volts, where α is a positive coefficient, and fe is the carrier frequency. (a) Determine the value of α when the modulation index is 100%. (b) Determine the value of α when the modulation index is 50%. (c) Determine the value of α when the modulation index is 200%. (6 marks) Continue from (1) and suppose α-05. Sketch the spectrum of the transmitted...
When the message signal m (t) =cos (2π fmt) and the carrier signal is c(t)=cos (2π fct) , fm<&...
When the message signal m (t) =cos (2π fmt) and the
carrier signal is c(t)=cos (2π fct) ,
fm<< fc,
The modulated DSB-SC signal
SDSB-SC=m(t)cos(2πfct) is generated, and only
the upper sideband
To generate and transmit the SSB signal. As shown in the figure
below, the receiver is a local oscillator
cosine signal to the received signal and passes it through a
low-pass filter. Answer the following questions.
(a) Draw the waveform of DSB-SC modulated signal
SDSB-SC(t）
(b)Find the result...
Problem A DSB-SC AM signal is modulated by the signal m(t) = cos(4000st) - cos(1000nt). The...
Problem A DSB-SC AM signal is modulated by the signal m(t) = cos(4000st) - cos(1000nt). The modulated signal is u(t) = 200 m(t) cos(21tfct), where f=1 MHz. 1. Determine and sketch the spectrum of the AM signal. 2. Determine the average power in the frequency components 3. Find a resonable choice of R and C to design an envelope detector for this DSB-SC AM signal.
Find the instantaneous frequency of the next signal at t = 4. (a) x(t) = 10...
Find the instantaneous frequency of the next signal at t = 4. (a) x(t) = 10 cos[20xt+10 sin(t/4)) (b) x(t) = 262719) () X(t)=10[cos(2nt) cos(atº/4) + sin(24t) sin( nt/ 4)] Suppose that the information signal is as shown in the following figure. When each modulating this signal using 100KHz as the carrier frequency, find the frequency shift and phase shift when FM is modulated with 5,=10. What is the maximum frequency shift and maximum phase shift? 0.5+ -0.5 ost Suppose...
Power Spectrum of AM A baseband message signal is given byWn (t)-5 cos 2π 2500t + 4 cos 2π 5500. An AM waveform carrying this message g(t)-50[1 + μ m(t) mp]cos 2π5x 109, where mp s the peak value of m(t a) Plot (by hand) the power spectrum S (f) of the AM waveform g(t) with 0.6 (You can get help with this from the handout A Power Spectrum Primer. See the section "Finding the Power Spectrum of a Periodic...
Sketch the frequency spectrum of he following signal and
indicate the complex magnitude of each. All amplitudes must be
positive
Determine fundamental frequency and period
*all phases need to be written in terms of pi between
-pi and pi.
Sketch the frequency spectrum of the following signal and indicate the complex magnitude of each frequency component Manipulate phase as necessary to plot all components of the spectrum with positive amplitudes: x(t) = 14 cos( 1 60mt-π/4) + 5 cos(280mt-2π/3) -cos(600πt...
Consider an AM system. The message signal is given by cos(1000t) volts. The modulated signal is (0.5+acos(1000m))cos(2π.) volts, where α is a positive coefficient, and fe is the carrier frequency. (a) Determine the value of α when the modulation index is 100%. (b) Determine the value of α when the modulation index is 50%. (c) Determine the value of α when the modulation index is 200%. (6 marks) Continue from (1) and suppose α-05. Sketch the spectrum of the transmitted...
When the message signal m (t) =cos (2π fmt) and the
carrier signal is c(t)=cos (2π fct) ,
fm<< fc,
The modulated DSB-SC signal
SDSB-SC=m(t)cos(2πfct) is generated, and only
the upper sideband
To generate and transmit the SSB signal. As shown in the figure
below, the receiver is a local oscillator
cosine signal to the received signal and passes it through a
low-pass filter. Answer the following questions.
(a) Draw the waveform of DSB-SC modulated signal
SDSB-SC(t）
(b)Find the result...
Problem A DSB-SC AM signal is modulated by the signal m(t) = cos(4000st) - cos(1000nt). The modulated signal is u(t) = 200 m(t) cos(21tfct), where f=1 MHz. 1. Determine and sketch the spectrum of the AM signal. 2. Determine the average power in the frequency components 3. Find a resonable choice of R and C to design an envelope detector for this DSB-SC AM signal.
Find the instantaneous frequency of the next signal at t = 4. (a) x(t) = 10 cos[20xt+10 sin(t/4)) (b) x(t) = 262719) () X(t)=10[cos(2nt) cos(atº/4) + sin(24t) sin( nt/ 4)] Suppose that the information signal is as shown in the following figure. When each modulating this signal using 100KHz as the carrier frequency, find the frequency shift and phase shift when FM is modulated with 5,=10. What is the maximum frequency shift and maximum phase shift? 0.5+ -0.5 ost Suppose...
Most questions answered within 3 hours.
-
The resistance of the body varies from approximately 500 kΩ
(when it is very dry) to...
asked 13 seconds from now -
Please explain how participation income and expenses are
allocated to each partner. Where is this defined?
asked 9 minutes ago -
The tires of a car make 61 revolutions as the car reduces its
speed uniformly from...
asked 24 minutes ago -
Peabody, Inc., sells fireworks. The company’s marketing director
developed the following cost of goods sold budget...
asked 28 minutes ago -
A signal transduction pathway includes the steps listed
below.
1. An inactive signal transduction molecule is...
asked 27 minutes ago -
1. The correlation coefficient determined for two variables has
a value of 0.89. Describe, in words,...
asked 33 minutes ago -
The following data relate to direct materials costs for
November:
Actual costs
4,700 pounds at $5.35...
asked 32 minutes ago -
Kyle, a 95.0 kg football player, leaps straight up into the air
(with no horizontal velocity)...
asked 56 minutes ago -
Which of the following is a measure of profitability?
A.
Quick (acid-test) ratio
B.
Net sales...
asked 58 minutes ago -
Find the total pressure exerted by 2 grams of ethane and 3 grams
of CO2 contained...
asked 1 hour ago -
A fireman standing on a 5.2 m high ladder operates a water hose
with a round...
asked 56 minutes ago -
A cream formulation is studied for accelerated stability study.
Creaming was observed when formulation was tested...
asked 59 minutes ago